Remote Programming Procedures
Because the CompuStar systems are modular in design (upgradeable), the remotes Do Not come
Programming for:
1WAM4R (all versions), 1WFM4R (all versions), 1W900FM4R (all versions), and for programming the 1WSS4R as a standalone remote:
1.Insert the key into the ignition and turn the ignition ON then OFF five times.
2.The fifth time you turn the ignition on, the parking lights will flash once.
3.Tap the Top Left button on the transmitter once. The parking lights will again flash once to confirm that the remote was coded.
4.After a few seconds, the parking lights will flash twice to signal the ending of the remote programming mode.
If you have multiple remotes, you can program them all at once by coding the first remote, then right after getting the confirmation flash, coding the second remote (you will get another confirmation flash), and then coding the third remote.
Programming for:
1WSS4R, when using it in conjunction with the 2WSSR.
If you plan to use the 2WSSR and the 1WSS4R together, you must program them at the same time.
1.Pull the positive side of the battery out of the 2WSSR, do not remove the whole battery as you will need to quickly insert it again.
2.Insert the key into the ignition and turn the ignition ON then OFF five times.
3.The fifth time you turn the ignition on, the parking lights will flash once.
4.Quickly push the positive side of the battery back into the 2WSSR. The parking lights will flash once to confirm that the remote was coded.
5.Immediately after, tap the Top Left button on the 1WSS4R once. The parking lights will again flash once to confirm that the remote was coded.
6.After a few seconds, the parking lights will flash twice to signal the ending of the remote programming mode. Do not press any buttons on either remote, the 2WSSR will still be in the process of synchronizing. As soon as the 2WSSR chirps once or twice, you are finished and can use the remotes. This should only take a few seconds.
-7 -