CM3000 | Firstech, LLC CM4200, CM3 SERIES, CM1000A instruction

the lock and rearm pulses to the vehicle while the dome light output is active. This will simulate the door being opened and the lock button being pressed, therefore arming the factory alarm.

1-7 – Turbo Mode

If enabled, this option will allow the system to be put in Turbo mode through the remote. In Turbo mode, the system will keep the vehicle running until two minutes after the ignition has been turned to the OFF position, if the emergency brake wire has been grounded. This feature is useful for vehicles with turbochargers because it allows the turbo too slowly cool before shutting off the engine. To use Turbo mode, you must turn on option 1-7, enable Turbo mode on the remote, and set the emergency brake.

1-8 – Diesel Timer Mode

With this option on the default setting, the CompuStar system will remote start normally unless it senses input on either the ( + ) or ( - ) glow-plug input wires. If it senses input on either one of these wires, it will delay the start until the input goes away. With this option on the optional setting, the system will turn on the ignition wires then wait 18 seconds before starting. This 18 second delay is adjustable between 3 and 99 seconds, but only with the CM3 Series Option Programmer.

1-9 – CM3000:

Delayed Door Trigger for Locking

With this option turned on, the system will ignore the door trigger for 90 seconds after the lock command has been issued. This will prevent the “door open” indication on 2-way remotes. If the door is still seen as open after 90 seconds, the remote will be paged to indicate that the door is still open.

CM4200

Short Pulse Lock/Unlock

With this option enabled, the output duration of the door lock will be reduced from 0.8 seconds to 0.125 seconds.

1-10 – Starter Kill Relay

With this option on the default setting, the starter kill relay will act as an anti- grind circuit only, and will not disable the starter when the system is locked. In the optional setting, the starter kill relay will act as an anti-grind and starter kill circuit.

1-11 – CM3000

Valet Option for RPS Sensor

With this option turned off, the RPS sensor will not be activated. (Continued…)

- 56 -