Install Checklist
Please use this checklist to complete the installation of any CompuStar system. These steps should be done in the order shown.
Prep/Install Module:
Begin preparing the system for installation by removing any wires you are not going to be using, leave some of the wire in case you need to use it in the future. Then wire up any relays, etc., and install the control module in the vehicle.
Code Remote:
Code the remote using the remote coding procedure shown in this manual. The remotes do not come preprogrammed as a result of the modular design of the CompuStar lineup.
Program Tach:
Program tach by tapping the tach learn button located on the back of the control module.
Set Options:
Using the Option Programming section of this manual, set the options of the control module.
Test:
Test the system by testing and adjusting the shock sensor, testing the remote start process, and verifying all of the alarm triggers.
- 4 -