
Operation
Set LAN-based Decode options
Use following steps to display Decoder Source screen on the OSD menu:
1.Navigate to the Decoder Setup screen
2.Press the up or down arrow buttons to select Decoder Source.
3.Press Enter.
4.Press the up or down arrow buttons to select either
5.Press Enter.
6.Select Activate Settings.
7.Press Enter.
Figure 3.15: iPump 562 OSD Decoder Source
Use the Decoder Source screen to set and display the LAN Decode options.
| Table 3.9: LAN Decode Options | |
|
|
|
Option |
| Possible values |
|
|
|
| Multicast or Unicast IP Address | |
|
|
|
| The corresponding IP Port number | |
|
|
|
Audio Routing |
| Stereo or Left/Right on both |
|
|
|
Audio Attenuation |
| 0 through 20 |
|
|
|
S/PDIF Mode |
| Passthru, Linear PCM or Off |
|
|
|
Set LAN IP Networking options
Use following steps to display LAN IP Setup screen on the OSD menu:
1.Navigate to the Unit Setup screen, see Unit Setup screen on page 23.
2.Press the down arrow button to select LAN IP Setup.
3.View the details as shown in Figure 3.16.
26 | www.wegener.com |