Sony NSX-A767 manual Timer Recording

3,4 ‘d J

TIMER

SHIFT

1 ( 8.!

5	Adjust	the volume.	a
	The source sound will play at the volume level set in this step		i
	when the power is turned on by the timer.
			‘~’
	If the volume level is set to 21 or higher, however, it will
	automatically be set to 20 when the power is turned on.		::~
6	Prepare	the source.	!,’
			‘,, ,
	To listen	to a CD, load the disc to be played first on tray 1.	;~’,
	To listen	to a tape, insert the tape into deck 1 or 2.	‘~’
	To listen to the radio, tune in to a station.		o

7 Press POWER to turn off the power.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

m

You can change the source that was selected in step 1 by pressing one of the function buttons before pressing ENTER or 11 in step 3.

To check the timer setting

The unit can be turned on at a specified time every day with the built-in timer,

Preparation

Make sure the clock is set correctly.

1 Press one of the function buttons to select a source.

*If TUNER/BAND is pressed, the band cannot be selected in this step,

2 Press TIMER repeatedly until ~ appears on the display.

Press TIMER.

The selected source, the timer-on time, and the duration for the timer-activated period will be displayed for 4 seconds.

To change any of the previous setting

Carry out from step 1.

However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily Press TIMER re~eatedlv so that @ disarmears.

To restore the timer sta;dby mode, press again to display ~.

When using the remote control, press TIMER while pressing

SHIFT.

Time and audio source name flash alternately.

o

Using the unit while the timer is set

You can use the unit normally after setting the timer. Before turning off the power, carry out step 5 and 6.

Im

●Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

3 Within 6 seconds, turn MULTI JOG to designate the timer-on time, then press ENTER or HM.

Turning MULTI JOG changes both the hour and the minute.

+or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

4 Within 4 seconds, turn MULTI JOG to select the duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5- minute steps.

+or B+ is also available instead of MULTI JOG,

The duration will be automatically set after 4 seconds. It will also be set if IENTER or II is pressed within 4 seconds after step 4.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press either TUNER/BAND or VIDEO/AUX to select a source, then press TIMER repeatedly until @REC lights up on the display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after steo 6,

m

●When the power-economizing mode (page 7) has been turned on, the timer recording volume level will be O (minimum level).

●You cannot use the timer function to record from a CD or tape.

ENGLISH 27