Sony NSX-A767 manual Line OUT Jacks, Press VIDEO/AUX or MD, Play the connected equipment

F		CD DIGITAL OUT
		(OPTICAL)
=		VIDEO/AUX
●		WOOFERS
L’TA
		MD
●	** LINE OUT

i SUPER

&

Refer to the operating instructions of the connected equipment for details.

●The connecting cords are not supplied. Obtain the necessary connecting cords.

●Consult your local Aiwa dealer for optional equipment.

This unit can input analog sound signals through these jacks. Use a cable with RCA phono plugs to connect audio equipment (turntables, LD players, MD players, VCRs, TV, etc.).

Connect the red plug to the VIDEO/AUX R jack, and the white plug to the VIDEO/AUX L jack.

When connecting a turntable

Use an Aiwa turntable equipped with a built-in equalizer amplifier.

This jack is recommended to connect with an MD player. Use a cable with RCA phono plugs.

Connect the red plug to the MD R jack, and the white plug to the MD L jack.

LINE OUT JACKS

This unit can output analog sound signal through these jacks. Use a cable with RCA phono plugs to connect audio equipment with LINE IN (analog input) jacks.

Connect the red plug of a cable to LINE OUT R jack, and the white plug to LINE OUT L jack.

m

Do not connect an equipment to LINE OUT jacks and VIDEO/ AUX jacks simultaneously. Otherwise, noise is generated and malfunction occurs.

This unit can output CD digital sound signals through this jack. Use an optical cable to connect digital audio equipment (DAT deck, MD recorder, etc.).

Remove the dust cap @ from the CD DIGITAL OUT (OPTICAL) jack. Then, connect an optical cable plug to the CD DIGITAL OUT (OPTICAL) jack.

When the CD DIGITAL OUT (OPTICAL) jack is not being used

Attach the supplied dust cap.

28 ENGLISH

Connect optional powered sub woofers with built-in-amplifier to the jacks.

IL—. .,. . .._.l_.. .—J

r“--–‘t-i

To play a equipment connected to VIDEO/AUX jacks or MD jacks proceed as follows.

1 Press VIDEO/AUX or MD.

To plav the equipment connected to VI DEO/AUX, press VIDEO/AUX. “VIDEO”appears on the display,

To play the eaui~ment connected to MD, press MD. “MD” appears on the display.

2 Play the connected equipment.

To change a source name in the display

When VIDEO/AUX is pressed, “VIDEO” is displayed initially. It can be changed to “AUX or “TV.

With the power on, press POWER while pressing ViDEO/AUX. Repeat the procedure to select one of the names.

To adjust the sound level of the external source

When the sound level of the external source is much higher or much lower than that of other function sources, adjust it as follows.

1Press VIDEO/AUX or MD and play the equipment.

2Presss < or -so that the sound level becomes the same as that of other function sources.

During recording, the sound level can not be adjusted.

,.