Samsung 4 CHANNEL DVR, SDE-3003, SDE-3001 user manual Before Start, Battery

Page 5
CALIFORNIA USA ONLY
This Perchlorate warning applies only to primary CR (Manganese Dioxide) Lithium coin cells in the product sold or distributed ONLY in California USA. “Perchlorate Material - special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate.”

BEFORE START

This user manual provides Information for using the DVR such as brief introduction, part names, functions, connection to other equipment, menu setup, etc.

You have to keep in mind the following notices :

•SAMSUNG retains the copyright on this manual.

•This manual cannot be copied without SAMSUNG’s prior written approval.

•We are not liable for any or all losses to the product incurred by your use of non-standard product or violation of instructions mentioned in this manual.

•Prior to opening the case, please consult a qualified technician first. Whenever this is needed power must be removed from the unit.

•Before installing an additional HDD or connecting an external storage device (USB memory or USB HDD) to this DVR, check the compatibility. Consult your provider for the compatibility list.

Warning

❖Battery

It is essential that when changing the battery in the unit, the replacement battery must be of the same type otherwise there may be a possibility of an explosion.

The following are the specifications of the battery you are using now.

•Normal voltage : 3V

• Normal capacity : 170mAh

• Continuous standard load : 0.2mA

• Operating temperature : -20°C ~ +85°C (-4°F ~ +185°F)

JConnect the power cord into a grounded outlet.

The Mains plug is used as a disconnect device and shall stay readily operable at any time.

Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

❖System Shutdown

Turning off the power while the product is in operation, or undertaking improper actions may cause damage or malfunction to the hard drive or the product.

Please turn off the power using the Power button on the front of your DVR. After selecting <OK> in the pop-up menu, you can pull off the power cord.

You may want to install a UPS system for safe operation in order to prevent damage caused by an unexpected power stoppage. (Any questions concerning UPS, consult your UPS retailer.)

❖Operating Temperature

The guaranteed operating temperature range of this product is 0°C ~ 40°C (32°F ~ 104°F).

This product may not work properly if you run right after a long period of storage at a temperature below the guaranteed one.

Prior to using a device that has been stored for a long period in low temperatures, allow the product to stand at room temperature for a period.

Especially for the built-in HDD in the product, its guaranteed temperature range is 5°C ~ 55°C (41°F ~ 131°F). Likewise, the hard drive may not work at a temperature below the guaranteed one.

OVERVIEW

English _5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Channel DVR Channel DVR  Overview Important Safety InstructionsOverview Before Start BatteryContents Using Search Viewer Using Live ViewerViewer Setup SEC Backup ViewerFeatures Standards Approvals Package ContentsPart Names and Functions Front Part Names and Functions Rear Changing the Remote Control ID Remote ControlUsing the Numeric buttons Checking the Installation Environment Installation Connecting with Other Device Only one mouse port is available Connecting the VIDEO, AUDIO, and MonitorConnecting the USB  Connecting with Other Device Connecting the CameraRJ-45 Cable Length 18.3m, 60ft IR LEDCamera Bracket Installing the cameraCamera Bracket Specification Adjusting the Camera Bracket Connecting the alarm output signal Connecting the Alarm INPUT/OUTPUTConnecting the alarm input signal Connecting to the Network using the router Connecting the NetworkConnecting to Network through Ethernet 10/100BaseT Internet Connecting to Internet through AdslStarting the system Getting StartedShutting Down the System  LiveLocking All Buttons LoginLive Live Screen ConfigurationIcons on the Live Screen Split Mode Menu Error InformationSplit Mode Menu Live Screen MenuSingle Mode Menu System Date/Time/Language Time. Alarm FreezeView the Launcher Menu Switching the screen mode Live ModeSwitching the screen automatically PIPSwitching to Single Mode Channel SettingSpot OUT Selecting a Spot Out modeZoom Multichannel Live MenuAudio ON/OFF Audio ON/OFF in Single modeFreeze Event MonitoringCH2 Date/Time/Language System SetupSetting the Date/Time/Language Using the Calendar Setting HolidayUsing Virtual Keyboard Setting the AdministratorPermission Management Permission ManagementTo set the group authority Setting the GroupTo restrict the user permissions To change the user passwordSetting Permissions Setting the UserWhen the user setup is done, press OK  Using the DVRSystem Management System ManagementChecking the System Information Updating the Software  UsingSystem Log SettingsLog Information Event Log Backup LogUse the up/down buttons Select Event Log Use direction buttonsSetting the Camera Setting the DeviceCamera Press Enter buttonStorage Device When the camera setup is done, press OKConfirming Devices You can check information on storage devicesYou can format a storage device FormattingSelect Format FormattedRemote Device HDD AlarmRemote Devices Setting Display position Setting the MonitorMonitor Move to Monitor, and press Enter buttonSetting the Screen Mode Setting the Spot OutRecording Schedule Setting the RecordingRecord Recording ScheduleSetting Standard Recording Properties REC Quality / ResolutionEvent Record Duration Recording Color TagsRecord Option Setting Event Recording PropertiesWindow of sensor detection setup appears Setting the EventSensor Detection Detection, and press Enter buttonMotion Detection Setting the Motion Detection AreaWindow of video loss detection area setup appears Alarm ScheduleWhen the Alarm Schedule setup is done, press OK Video Loss DetectionSetting the Backup BackupYou can backup the desired data to a connected device BackupConnection Mode Network ConfigurationSetting the Connection You can set the network connection route and protocolMove to Connection Mode, and press Enter Setting the ProtocolWhen no router is used Connecting and Setting the NetworkInternal Port Range Set the same to the External Port Range When a router is usedLive Transfer Ddns SettingLive Transfer Event Setting Mailing ServiceSmtp Setting When the recipient setting is done, press OK Group SettingRecipient Setting Search It does not appear in Backup SearchTime Search You can search for recorded data of a desired timeSearch & Play Backup SearchEvent Search Motion Search Motion SearchPlayback Backup RangePlay  For data search, refer to Search.REC Records all channels in Live mode Partial Backup Using the Playback ButtonMode Switch DVR set WEB Viewer What is Web Viewer?Introducing WEB Viewer Click Install Connecting WEB ViewerUsing Live Viewer Single Mode You can change the split mode by clicking each number iconQuad Mode Full Screen ModeConnected DVR Setting the display of the OSD time informationCapture Saves the current screen into a BMP or Jpeg file Saving the Live Screen on the PCUsing Search Viewer SPLIT-SCREEN Saving the Live Screen on the PC Searching the Recorded Video in the Calendar You can configure the various settings of the DVR system Viewer SetupSystem Date/Time/LanguagePermission Management HolidaySystem Management Storage Device DeviceCamera Monitor Remote DeviceRecord For more information, refer to Setting the Recording.Recording Schedule Event Record DurationEvent REC Quality & ResolutionRecord Option Sensor DetectionYou can set the alarm output time if a video loss occurs Alarm ScheduleMotion Detection Video Loss DetectionYou can check the Ddns settings For more information, refer to Network Configuration.Network ConnectionSmtp Mailing ServiceKey Features What is Mobile Viewer?About Mobile ViewerRecommended System Requirements SEC Backup Viewer Backup Viewer UTP Product Specification Camera Appendix Weight 300g 115gHumidity Mechanical 500GB Sata HDD 1TB Sata HDD Product SpecificationHdmi Management Default SettingCategory Details Factory Default 4CIFL DurationSmtp Troubleshooting 4CIF 2CIFCIF Preamble Open Source License Report on the ProductVersion 2, June USAPage No Warranty GNU Lesser General Public License instead of this License How to Apply These Terms to Your New ProgramsSome devices are designed to deny users access to Source Code Terms and ConditionsConveying Verbatim Copies Additional Terms Automatic Licensing of Downstream Recipients Acceptance Not Required for Having CopiesRevised Versions of this License PatentsUse with the GNU Affero General Public License END of Terms and Conditions Limitation of LiabilityInterpretation of Sections 15 Page Modified work must itself be a software library Page How to Apply These Terms to Your New Libraries Original SSLeay License OpenSSL LicensePage Correct disposal of batteries in this product Chertsey, Surrey, United Kingdom KT16 OPS Sales Network
Top Page Image Contents