Samsung SRD-450 user manual Before Start, Battery

Page 6

overview

BEFORE START

This user’s manual provides Information for using DVR such as brief introduction, part names, functions, connection to other equipment, menu setup, and the like.

You have to keep in mind the following notices:

SAMSUNG retains the copyright on this manual.

This manual cannot be copied without SAMSUNG’s prior written approval.

We are not liable for any or all losses to the product incurred by your use of non-standard product or violation of instructions mentioned in this manual.

If you want to open the case of your system for checking problems, please consult the expert from the shop where you bought the product.

Before installing an additional HDD or connecting an external storage device (USB memory or USB HDD) to this DVR, check the compatibility. Consult your provider for the compatibility list.

Warning

Battery

Exchanging a wrong battery in your product may cause an explosion. Therefore you must use the same type of battery as the one being used in the product.

The following are the specifications of the battery you are using now.

Normal voltage: 3V

Normal capacity: 170mAh

Continuous standard load: 0.2mA

Operating temperature: -20°C ~ +85°C (-4°F ~ +185°F)

CALIFORNIA USA ONLY

This Perchlorate warning applies only to primary CR (Manganese Dioxide) Lithium coin cells in the product sold or distributed ONLY in California USA. “Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/ hazardouswaste/perchlorate.”

System Shutdown

Turning off the power while the product is in operation, or taking not permitted actions may cause damage to the hard drive or the product. Also it can cause a dysfunction to the hard disk while using the product. Please turn off the power using the Remote Controller or Mouse.

After entering password in the pop-up menu, you can turn off the power switch.

You may want to install a UPS system for safe operation in order to prevent damage caused by an unexpected power stoppage. (Any questions concerning UPS, consult your UPS retailer.)

Operating Temperature

The guaranteed operating temperature range of this product is 0°C ~ 40°C (32°F ~ 104°F).

This product may not work properly if you run right after a long period of storage at a temperature below the guaranteed one.

When using the device after a long period of storage at low temperature, place the product at room temperature for a while and run it.

Especially for the built-in HDD in the product, its guaranteed temperature range is 5°C ~ 55°C (41°F ~ 131°F). Likewise, the hard drive may not work at a temperature below the guaranteed one.

Ethernet Port

This equipment is in door use and all the communication wirings are limited to inside of the building.

MMouse is optional (not included in the pack). Please consult compatibility list with Manufacturer.

6_ overview

Image 6
Contents SRD-450 Features OverviewImportant Safety Instructions OverviewRisk of Electric Shock Do not Open English Battery Before StartPackage Contents Standards ApprovalsContents Using the iPhone BackupSetup Product SpecificationPart Names and Functions Front MenuLED Part Names and Functions Rear Remote Control DVRChanging Remote Control ID Connecting the Alarm I/O Connecting with other deviceConnecting the AUDIO, SPEAKER, MOUSE, and Power Cable Connecting the alarm Input signalConnecting with Other Device Network ConnectionLocal System Configuration Total System Configuration InternetLOG on Getting startedStarting the System Getting StartedPower OFF LOGLOG OFF Icons on the Live Screen Live Screen ConfigurationLive DescriptionView the Launcher Menu Record Switching the screen modeDisplay Auto SequenceTo playback by time option PlaybackPlayback Screen To playback by time selectionSystem Setup DVR setupBefore Starting Setting UP How to use remote control and mouseSystem DATE/TIMEYYYY/MM/DD, DD/MM/YYYY, MM/DD/YYYY System Management To update the network Remote ControllerTo update the firmware File in the networkCamera Using the Virtual KeyboardCamera To change the camera titleColor CovertAudio Connection To select a motion area SetupMotion Sensor To deselect the motion areaOSD MonitorSequence Adding SequenceWhen the ADD Sequence window appears, press the ADD button Select a list to edit Edit window appearsAudio You can use the remote control to activate the buzzerSound BuzzerUser User ManagementTo add a user account User Authority To change the user informationDNS Server will be automatically filled IP SetupNetwork ServerDdns To view the HelpSecurity Network Connection and SettingsMail DVRStatic IP Setup Mode If not using a router for network connectionIf using a router Dynamic IP Dhcp Setup ModeDVR Connection Event / SensorHDD Event Router Port ForwardingAlarm Input Event / SensorAlarm Output Mode Set the output mode of the alarmBuzzer OUT Mail Notification Overwrite It will be disabled if Overwrite is set to OFFDisk Management If set to ON, recording will proceed by overwritingRecord Setup To start the Record SetupRecording Operation To set the record mode CONTINUOUS/MOTION RecordingTo specify the recording size/FPS/quality Adjust the size Alarm RecordingUse the direction buttons to move to Alarm From the Time bar, select a cell that you want toYou can specify the recording size in manual recording mode To specify the alarm recording timeFrom the Alarm Recording menu screen, select Activation Instant RecordingBackup BackupNEW Backup Reserved Data Management ReleaseSearch by Time Search & playSearch PlaybackSearch by Event Right Moves to the rightmost of the log listIntroduction What is web viewer?Web viewer System RequirementsTo connect to the Web Viewer Web viewerEnglish Live Viewer Live Viewer At a GlanceSelect a channel to display on the screen To print the screen Switching between split modesTo record video Single SplitTo view the status ActiveX SettingScreen Capture To view the logSet the recording properties as necessary Search ViewerSearch Viewer At a Glance TimelineSearch by Time Search by EventCamera Setting SetupSetup Viewer At a Glance Click the Setup tab to display the DVR remote setup screenColor setting Motion settingOSD setting Date/Time setting Monitor settingAudio/Buzzer setting Management settingContinuous/Motion Recording Setting Control Device SettingRecording Operation Setting Alarm Recording SettingInstant Recording Setting User Management SettingUser Authority Setting HDD Event Setting IP Setup SettingMail Setting Alarm Input SettingMail notification setting Alarm output settingBuzzer out setting InformationUsing the iPhone Product Specification AppendixDHCP, DNS, DDNS, NTP Ntsc ENGLISH/FRANÇAIS/ESPAÑOLРУССКИЙ/SVENSKA/ČESKÝ AVIPreamble Open Source License Report on the ProductGNU General Public License Version 2, JunePage No Warranty END of Terms and ConditionsHow to Apply These Terms to Your New Programs Some devices are designed to deny users access toGNU Lesser General Public License instead of this License Terms and Conditions Source CodeConveying Verbatim Copies Additional Terms Acceptance Not Required for Having Copies Automatic Licensing of Downstream RecipientsPatents Use with the GNU Affero General Public LicenseRevised Versions of this License Interpretation of Sections 15 GNU Lesser General Public LicenseLimitation of Liability END of Terms and ConditionsPage Modified work must itself be a software library Page How to Apply These Terms to Your New Libraries OpenSSL License Original SSLeay LicensePage Correct disposal of batteries in this product Channel DVR Chertsey, Surrey, United Kingdom KT16 OPS TEL +44-1932-45-5300 FAX +44-1932-45-5325