Barco RCP-120 Serial Port 1 Configuration / Baud Rate, Serial Port 2 Configuration / Baud Rate

Page 21

Serial Port 1 Configuration / Baud Rate

This section allows a user to change the Serial Port communication settings for the serial port on the rear panel of the RCP120. This serial port is used to access the RCP120 Boot Menu as a secondary method for configuring the panel. Under normal circumstances, it will not be necessary to use this method unless the Web interface can not be accessed.

Figure 35: Serial Port 1 Configuration

Default settings for this serial port are

∙9600 Baud Rate

∙8 Data bits

∙1 Stop bit

∙No Parity

Note

If necessary, set “Flow Control” to NONE in your communication software package.

Serial Port 2 Configuration / Baud Rate

This serial port is NOT supported on the RCP120.

Serial Port 1 Auto Transmit

This feature is NOT supported on the RCP120.

Remote Control Panel User’s Guide ● Rev 00

21

Image 21

Contents RCP120 Remote Control Panel User’s Guide Copyright Remote Control Panel User’s Guide RevTrademarks Company AddressUse the Proper Power Cord Power SourceDo Not Remove Covers or Panels Grounding the ProductTerms In This Manual and Equipment Marking Description Approved By 09/11 586290 Initial Release Rev DateTable of Contents Universal Power Supply This page intentionally left blank Overview IntroductionApplication Questions Connectivity DiagramRemote Control Panel Orientation RCP120 Front PanelRCP120 Rear Panel 2in Phoenix DC Power Input 4in Phoenix RS32 / IRLAN Installation Unpacking and InspectionWhat’s Included in the Box RCP120 Installation RCP120 Configuration Soft Reboot / Web Interface Password ResetConnecting to the RCP120 Web Interface Remote Control Panel User’s Guide Rev RCP120 Configuration RCP120 Configuration Web Interface Network ConfigurationStatus Master Controller IP Address Change Admin PasswordSerial Port 1 Configuration / Baud Rate Serial Port 2 Configuration / Baud RateSerial Port 1 Auto Transmit Update and Reboot / Reset Defaults Button SettingsSeconds Before Default Setting is 0 No Timeout. Used to Delay Between Default Setting is 30 0.3 Seconds. Used toRCP120 Boot Menu Connecting to the Boot MenuOverview RCP120 Boot Menu Interface Discard Changes and Reboot Restore Default SettingsSave Changes and Reboot Selections Not SupportedAssign Remote Panels RCP120 FSN Menu OrientationFigure below illustrates the Remote Control Panel Table Remote Control Panel TableAssign Remote Panels Menu Functions Discover Remote Panels Assign Aux UnassignInfo Duplicate IP Address Notification Operations No Connection BehaviorDisplay IP/MAC Address and Firmware Version Understanding Button Mapping AUX Output ControlButton Color Table Understanding Button ColorWorking with the RCP120 Remote Control Panel User’s Guide Rev Setting up the RCP120 to Control an Aux Output FSN System and Controller SetupRCP20 Setup Adding Additional RCP20 Devices Maintenance OperationsUnassign an Aux Output from an RCP20 Working with an Unconnected RCP20Controlling a Standard Aux Output Controlling an Aux Output with the RCP120Program Preview Controlling an Aux Output defined as a MixerSoftware Update Overview Updating SoftwareHardware Requirements Downloading Software Via FTP SiteRCP20revision #.zip Via Web Site RCP20 Firmware Upload Updating RCP120 SoftwareRemote Control Panel User’s Guide Rev Physical and Electrical Specifications SpecificationsAgency Specifications Communications SpecificationsPower Connector Connector SpecificationsSerial Port Figure below illustrates the 4pin Phoenix powe r connectorInstalling a Power Blade Adapter Universal Power SupplyRemote Control Panel User’s Guide Rev Warranty Return Material Authorization RMAContact Information Barco, Inc Contact InformationSales Contact Information Barco N.V