Barco RCP-120 manual Working with the RCP120

Page 34

Working with the RCP120

When using the RCP120 to control Aux Outputs, the panel will go through different stages during setup as it becomes ready to use. The following illustrations show these stages during a typical configuration session.

1. Before power is applied.

2.After power is first applied and a connection has not yet been established or the connection between the RCP120 and FSN Controller i s lost.

3.A connection between the RCP120 and FSN Controller is established; however the panel has yet to be assigned to an Aux Output.

4.A connection between the RCP120 and FSN Controller is established and the panel has been assigned to an Aux Output defined as “Standard”. The text in buttons 1 – 10 are for illustrative purposes only.

5.A connection between the RCP120 and FSN Controller is established and the panel has been assigned to an Aux Output defined as one of the following mixer types, “Mixer”, “Mixer – PGM” or “PGM/PVW”. The text in buttons 1 – 10 are for illustrative purposes only.

34	Remote Control Panel User’s Guide ● Rev 00

Image 34

Contents RCP120 Remote Control Panel User’s Guide Remote Control Panel User’s Guide Rev CopyrightCompany Address TrademarksDo Not Remove Covers or Panels Power SourceUse the Proper Power Cord Grounding the ProductTerms In This Manual and Equipment Marking Rev Date Description Approved By 09/11 586290 Initial ReleaseTable of Contents Universal Power Supply This page intentionally left blank Introduction OverviewConnectivity Diagram Application QuestionsRCP120 Front Panel Remote Control Panel OrientationRCP120 Rear Panel 4in Phoenix RS32 / IR 2in Phoenix DC Power InputLAN Unpacking and Inspection InstallationWhat’s Included in the Box RCP120 Installation Soft Reboot / Web Interface Password Reset RCP120 ConfigurationConnecting to the RCP120 Web Interface Remote Control Panel User’s Guide Rev RCP120 Configuration Network Configuration RCP120 Configuration Web InterfaceStatus Change Admin Password Master Controller IP AddressSerial Port 2 Configuration / Baud Rate Serial Port 1 Configuration / Baud RateSerial Port 1 Auto Transmit Seconds Before Default Setting is 0 No Timeout. Used to Button SettingsUpdate and Reboot / Reset Defaults Delay Between Default Setting is 30 0.3 Seconds. Used toConnecting to the Boot Menu RCP120 Boot MenuOverview RCP120 Boot Menu Interface Save Changes and Reboot Restore Default SettingsDiscard Changes and Reboot Selections Not SupportedRCP120 FSN Menu Orientation Assign Remote PanelsRemote Control Panel Table Figure below illustrates the Remote Control Panel TableDiscover Remote Panels Assign Aux Unassign Assign Remote Panels Menu FunctionsInfo Duplicate IP Address Notification No Connection Behavior OperationsDisplay IP/MAC Address and Firmware Version AUX Output Control Understanding Button MappingUnderstanding Button Color Button Color TableWorking with the RCP120 Remote Control Panel User’s Guide Rev FSN System and Controller Setup Setting up the RCP120 to Control an Aux OutputRCP20 Setup Unassign an Aux Output from an RCP20 Maintenance OperationsAdding Additional RCP20 Devices Working with an Unconnected RCP20Controlling an Aux Output with the RCP120 Controlling a Standard Aux OutputControlling an Aux Output defined as a Mixer Program PreviewUpdating Software Software Update OverviewHardware Requirements Via FTP Site Downloading SoftwareRCP20revision #.zip Via Web Site Updating RCP120 Software RCP20 Firmware UploadRemote Control Panel User’s Guide Rev Specifications Physical and Electrical SpecificationsPower Connector Communications SpecificationsAgency Specifications Connector SpecificationsFigure below illustrates the 4pin Phoenix powe r connector Serial PortUniversal Power Supply Installing a Power Blade AdapterRemote Control Panel User’s Guide Rev Return Material Authorization RMA WarrantyContact Information Sales Contact Information Contact InformationBarco, Inc Barco N.V