Barco RCP-120 manual Updating RCP120 Software, RCP20 Firmware Upload

Page 43

Updating RCP120 Software

Use the following steps to update the RCP120 softwa re.

1.Ensure that the correct version of the software has been properly downloaded from the website or the FTP site. If not, refer to the Downloading Software section above for instructions.

2.Unzip the file that was downloaded into the same folder to which the zip file was downloaded.

3.Refer to Connecting to the RCP120 Web Interface in Chapter 3 of this manual. Follow the steps indicated to open the RCP120 web page in your browser.

4.Click on the UPGRADE FIRMWARE link shown in the yellow box below to open the

RCP20 Firmware Upload page.

Figure 61: RCP120 Configuration – Upgrade Firmware

5.Click on the Browse button and navigate to the directory where the downloaded file was unzipped and select the “.bin” file.

Figure 62: RCP120 Firmware Upload

Remote Control Panel User’s Guide ● Rev 00

43

Image 43

Contents RCP120 Remote Control Panel User’s Guide Copyright Remote Control Panel User’s Guide RevTrademarks Company AddressGrounding the Product Power SourceUse the Proper Power Cord Do Not Remove Covers or PanelsTerms In This Manual and Equipment Marking Description Approved By 09/11 586290 Initial Release Rev DateTable of Contents Universal Power Supply This page intentionally left blank Overview IntroductionApplication Questions Connectivity DiagramRCP120 Front Panel Remote Control Panel OrientationRCP120 Rear Panel 4in Phoenix RS32 / IR 2in Phoenix DC Power InputLAN Unpacking and Inspection InstallationWhat’s Included in the Box RCP120 Installation Soft Reboot / Web Interface Password Reset RCP120 ConfigurationConnecting to the RCP120 Web Interface Remote Control Panel User’s Guide Rev RCP120 Configuration Network Configuration RCP120 Configuration Web InterfaceStatus Master Controller IP Address Change Admin PasswordSerial Port 2 Configuration / Baud Rate Serial Port 1 Configuration / Baud RateSerial Port 1 Auto Transmit Delay Between Default Setting is 30 0.3 Seconds. Used to Button SettingsUpdate and Reboot / Reset Defaults Seconds Before Default Setting is 0 No Timeout. Used toConnecting to the Boot Menu RCP120 Boot MenuOverview RCP120 Boot Menu Interface Selections Not Supported Restore Default SettingsDiscard Changes and Reboot Save Changes and RebootAssign Remote Panels RCP120 FSN Menu OrientationFigure below illustrates the Remote Control Panel Table Remote Control Panel TableAssign Remote Panels Menu Functions Discover Remote Panels Assign Aux UnassignInfo Duplicate IP Address Notification No Connection Behavior OperationsDisplay IP/MAC Address and Firmware Version Understanding Button Mapping AUX Output ControlButton Color Table Understanding Button ColorWorking with the RCP120 Remote Control Panel User’s Guide Rev FSN System and Controller Setup Setting up the RCP120 to Control an Aux OutputRCP20 Setup Working with an Unconnected RCP20 Maintenance OperationsAdding Additional RCP20 Devices Unassign an Aux Output from an RCP20Controlling a Standard Aux Output Controlling an Aux Output with the RCP120Program Preview Controlling an Aux Output defined as a MixerUpdating Software Software Update OverviewHardware Requirements Via FTP Site Downloading SoftwareRCP20revision #.zip Via Web Site RCP20 Firmware Upload Updating RCP120 SoftwareRemote Control Panel User’s Guide Rev Physical and Electrical Specifications SpecificationsConnector Specifications Communications SpecificationsAgency Specifications Power ConnectorSerial Port Figure below illustrates the 4pin Phoenix powe r connectorInstalling a Power Blade Adapter Universal Power SupplyRemote Control Panel User’s Guide Rev Return Material Authorization RMA WarrantyContact Information Barco N.V Contact InformationBarco, Inc Sales Contact Information