Barco RCP-120 manual Via Web Site

Page 42

Via Web Site

Barco’s web site address is: www.barco.com

To download software from the web site:

1.Create a target folder on your computer (e.g., RCP 120), and ensure that your PC is connected to the internet.

2.On the web, navigate to:

http://www.barco.com

3.Navigate to the “Presentation Systems” home page under Products Image Processing.

4.Click on the FSN Series multiformat switchers .

5.	Under Available Modules click on RCP20 .
6.	Click on the Downloads tab.
7.	Under Software click on RCP20 Software to start downloading the latest
	release.

8.When the File Download Dialog appears, click Save.

9.When the Save As Dialog appears, navigate to the target folder on your computer, and then click Save.

10.Continue with the Updating RCP20 Software section below.

42	Remote Control Panel User’s Guide ● Rev 00

Image 42

Contents RCP120 Remote Control Panel User’s Guide Remote Control Panel User’s Guide Rev CopyrightCompany Address TrademarksDo Not Remove Covers or Panels Power SourceUse the Proper Power Cord Grounding the ProductTerms In This Manual and Equipment Marking Rev Date Description Approved By 09/11 586290 Initial ReleaseTable of Contents Universal Power Supply This page intentionally left blank Introduction OverviewConnectivity Diagram Application QuestionsRemote Control Panel Orientation RCP120 Front PanelRCP120 Rear Panel 2in Phoenix DC Power Input 4in Phoenix RS32 / IRLAN Installation Unpacking and InspectionWhat’s Included in the Box RCP120 Installation RCP120 Configuration Soft Reboot / Web Interface Password ResetConnecting to the RCP120 Web Interface Remote Control Panel User’s Guide Rev RCP120 Configuration RCP120 Configuration Web Interface Network ConfigurationStatus Change Admin Password Master Controller IP AddressSerial Port 1 Configuration / Baud Rate Serial Port 2 Configuration / Baud RateSerial Port 1 Auto Transmit Seconds Before Default Setting is 0 No Timeout. Used to Button SettingsUpdate and Reboot / Reset Defaults Delay Between Default Setting is 30 0.3 Seconds. Used toRCP120 Boot Menu Connecting to the Boot MenuOverview RCP120 Boot Menu Interface Save Changes and Reboot Restore Default SettingsDiscard Changes and Reboot Selections Not SupportedRCP120 FSN Menu Orientation Assign Remote PanelsRemote Control Panel Table Figure below illustrates the Remote Control Panel TableDiscover Remote Panels Assign Aux Unassign Assign Remote Panels Menu FunctionsInfo Duplicate IP Address Notification Operations No Connection BehaviorDisplay IP/MAC Address and Firmware Version AUX Output Control Understanding Button MappingUnderstanding Button Color Button Color TableWorking with the RCP120 Remote Control Panel User’s Guide Rev Setting up the RCP120 to Control an Aux Output FSN System and Controller SetupRCP20 Setup Unassign an Aux Output from an RCP20 Maintenance OperationsAdding Additional RCP20 Devices Working with an Unconnected RCP20Controlling an Aux Output with the RCP120 Controlling a Standard Aux OutputControlling an Aux Output defined as a Mixer Program PreviewSoftware Update Overview Updating SoftwareHardware Requirements Downloading Software Via FTP SiteRCP20revision #.zip Via Web Site Updating RCP120 Software RCP20 Firmware UploadRemote Control Panel User’s Guide Rev Specifications Physical and Electrical SpecificationsPower Connector Communications SpecificationsAgency Specifications Connector SpecificationsFigure below illustrates the 4pin Phoenix powe r connector Serial PortUniversal Power Supply Installing a Power Blade AdapterRemote Control Panel User’s Guide Rev Warranty Return Material Authorization RMAContact Information Sales Contact Information Contact InformationBarco, Inc Barco N.V