AMX Mio Modero R-4 manual Bdo, Bfb, Bim

Programming the Mio R-4

"^" Button Commands (Cont.)

^BDO	Determines what order each layer of the button is drawn.
Set the button	Syntax:
draw order	"'^BDO-<vt addr range>,<button states range>,<1-5><1-5><1-5><1-
	5><1-5>'"
	Variable:
	• variable text address range = 1 - 4000.
	• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	• layer assignments = Fill Layer	= 1
	Image Layer = 2
	Icon Layer	= 3
	Text Layer	= 4
	Border Layer = 5
	Note: The layer assignments are from bottom to top. The default draw order is 12345.
	Example:
	SEND_COMMAND Device,"'^BDO-530,1&2,51432'"
	Sets the button’s variable text 530 ON/OFF state draw order (from bottom to top) to
	Border, Fill, Text, Icon, and Image.
	Example 2:
	SEND_COMMAND Device,"'^BDO-1,0,12345'"
	Sets all states of a button back to its default drawing order.
^BFB	Set the feedback type of the button. ONLY works on General-type buttons.
Set the feedback	Syntax:
type of the button	"'^BFB-<vt addr range>,<feedback type>'"
	Variables:
	• variable text address range = 1 - 4000.
	• feedback type = (None, Channel, Invert, On (Always on), Momentary, and Blink).
	Example:
	SEND_COMMAND Remote,"'^BFB-500,Momentary'"
	Sets the Feedback type of the button to 'Momentary'.
^BIM	Set the input mask for the specified address.
Set the input	Syntax:
mask for the	"'^BIM-<vt addr range>,<input mask>'"
specified address.
	Variable:
	• variable text address range = 1 - 4000.
	• input mask = Refer to the Input Commands section on page 79 for character types.
	Example:
	SEND_COMMAND Device,"'^BIM-500,AAAAAAAAAA'"
	Sets the input mask to ten ’A’ characters, that are required, to either a letter or digit
	(entry is required).

52 Mio Modero R-4