AMX Mio Modero R-4 manual Sendcommand DEV,LVM-view address,offset, Sendcommand Device,LVM-2,-4

	Programming the Mio R-4
List Box Commands (Cont.)
List View Commands
^LVM	Display a new position. If select is set, then select that new position.
Display a new position	Syntax:
	SEND_COMMAND <DEV>,"'^LVM-<view address>,<offset>'"
	Variables:
	• view address = the address of the view definition
	• offset = + / - numeric display shift
	Example:
	SEND_COMMAND Device,"'^LVM-2,-4'"
	Shifts the display -4 and displays the list according to the view definitions
	located at address 2.
^LVO	Display a data list according to a preset sort/ordering view definition. This
Display a data list according	command tells the view which of the possible orderings to use. Note that the
	<sort> field is a bitmask, so that the 3 bit positions may be combined.
to a preset sort/ordering view
definition.	Syntax:
	SEND_COMMAND <DEV>,"'^LVO-<view address>,<sort>'"
	Variables:
	• view address = the address of the view definition
	• sort = bitmask with the following bit assignments:
	0x0001 = Sort
	0x0002 = Reverse
	0x0004 = Filter
	Note: Of special note is the reverse bit (0x0002), which reverses the list what-
	ever order it is currently in. When used on a sorted list, it results in a reverse
	sort. When used on a reverse sorted list, it results in a forward sorted list. In
	most cases, the reverse bit should not be used alone, but should be used in
	combination with the sort bit (0x0003) such that it always results in a reverse
	sorted list.
	Possible values for the sort field:
	0 = None
	1 = Forward Sort
	2 = Reverse the current list ordering (may or may not be sorted)
	3 = Reverse Sort
	4 = Filter
	5 = Forward Sort + Filter
	6 = Reverse current + filter
	7 = Reverse sort + filter
	Example:
	SEND_COMMAND Device,"'^LVO-1,7'"
	Displays the data list according to the view definitions located at address 1 and
	filters and reverse sorts the list.

Mio Modero R-4 85