AMX Mio Modero R-4 manual Fon, Gdi, Giv, Glh

				Programming the Mio R-4
"^" Button Commands (Cont.)
^FON	Set a font to a specific Font ID value for those buttons with a defined address range. Font
Set a font to a	ID numbers are generated by the TPDesign4 programmers report.
	Syntax:
specific Font ID
value for those	"'^FON-<vt addr range>,<button states range>,<font value>'"
buttons with a
	Variable:
defined address
range	• variable text address range = 1 - 4000.
	• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	• font value = range = 1 - XXX. Refer to theFixed Fonts and ID Numbers table on page 37.
	Example:
	SEND_COMMAND Device,"'^FON-500.504&510.515,1&2,4'"
	Sets the font size to font ID #4 for the On and Off states of buttons with the variable text
	range of 500-504 & 510-515.
	Note: The Font ID is generated by TPD4 and is located in TPD4 through the Main menu.
	Panel > Generate Programmer's Report >Text Only Format >Readme.txt.
^GDI	Change the bargraph drag increment.
Change the	Syntax:
bargraph drag	"'^GDI-<vt addr range>,<bargraph drag increment>'"
increment
	Variable:
	• variable text address range = 1 - 4000.
	• bargraph drag increment = The default drag increment is 256.
	Example:
	SEND_COMMAND Device,"'^GDI-7,128'"
	Sets the bargraph with variable text 7 to a drag increment of 128.
^GIV	Invert the joystick axis to move the origin to another corner. Parameters 1,2, and 3 will
Invert the	cause a bargraph or slider to be inverted regardless of orientation. Their effect will be as
	described for joysticks.
joystick axis to
	Syntax:
move the origin to
another corner	"'^GIV-<vt addr range>,<joystick axis to invert>'"
	Variable:
	• variable text address range = 1 - 4000.
	• joystick axis to invert = 0 - 3.
				0 = Normal
		0	1
				1 = Invert horizontal axis
				2 = Invert vertical axis
		2	3
				3 = Invert both axis locations
	For a bargraph 1 = Invert , 0 = Non Invert
	Example:
	SEND_COMMAND Device,"'^GIV-500,3'"
	Inverts the joystick axis origin to the bottom right corner.
^GLH	Change the bargraph upper limit.
Change the	Syntax:
bargraph upper	"'^GLH-<vt addr range>,<bargraph hi>'"
limit
	Variable:
	• variable text address range = 1 - 4000.
	• bargraph limit range = 1 - 65535 (bargraph upper limit range).
	Example:
	SEND_COMMAND Device,"'^GLH-500,1000'"
	Changes the bargraph upper limit to 1000.

Mio Modero R-4 59