AMX Mio Modero R-4 manual Sendcommand Device,BMF-500,1,%B10%CFRed%CB Blue, CTBlack%Ptest.png, Bmi

	Programming the Mio R-4
"^" Button Commands (Cont.)
^BMF	For some of these commands and values, refer to theRGB Values for all 88 Basic
(Cont.)	Colors table on page 35.

•’%CF<on fill color>’ = Set Fill Color.

•’%CB<on border color>’ = Set Border Color.

•’%CT<on text color>’ = Set Text Color.

•’%SW<1 or 0>’ = Show/hide a button.

•’%ST<style>’ = Button style.

•’%EN<1 or 0>’ = Enable/disable a button.

•’%WW<1 or 0>’ = Word wrap ON/OFF.

•’%GH<bargraph hi>’ = Set the bargraph upper limit.

•’%GL<bargraph low>’ = Set the bargraph lower limit.

•’%GN<bargraph slider name>’ = Set the bargraph slider name/Joystick cursor name.

•’%GC<bargraph slider color>’ = Set the bargraph slider color/Joystick cursor color.

•’%GI<bargraph invert>’ = Set the bargraph invert/noninvert or joystick coordinate (0,1,2,3). ^GIV section on page 59 more information.

•’%GU<bargraph ramp up>’ = Set the bargraph ramp up time in intervals of 1/10 second.

•’%GD<bargraph ramp down>’ = Set the bargraph ramp down time in 1/10 second.

•’%GG<bargraph drag increment> = Set the bargraph drag increment. Refer to the ^GDI command on page 59 for more information.

•’%OT<feedback type>’ = Set the Feedback (Output) Type to one of the following: None, Channel,Invert, ON (Always ON), Momentary, or Blink.

•’%SM’ = Submit a text for text area button.

•’%SF<1 or 0>’ = Set the focus for text area button.

•’%OP<0-255>’ = Set the button opacity to either Invisible (value=0) or Opaque (value=255).

•’%OP#<00-FF>’ = Set the button opacity to either Invisible (value=00) or Opaque (value=FF).

•’%UN<Unicode text>’ = Set the Unicode text. See the^UNI section on page 64 for the text format.

•’%EF<text effect name>’ = Set the text effect.

•’%EC<text effect color>’ = Set the text effect color.

•’%ML<max length>’ = Set the maximum length of a text area.

•’%MK<input mask>’ = Set the input mask of a text area.

Example:

	SEND_COMMAND Device,"'^BMF-500,1,%B10%CFRed%CB Blue
	%CTBlack%Ptest.png'"
	Sets the button OFF state as well as the Border, Fill Color, Border Color, Text Color, and
	Bitmap.
^BMI	Mask image is used to crop a borderless button to a non-square shape. This is typically
Set the button	used with a bitmap.
mask image	Syntax:
	"'^BMI-<vt addr range>,<button states range>,<mask image>'"
	Variable:
	• variable text address range = 1 - 4000.
	• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	• mask image = Graphic file used.
	Example:
	SEND_COMMAND Device,"'^BMI-530,1&2,newMac.png'"
	Sets the button with variable text 530 ON/OFF state mask image to 'newmac.png'.

Mio Modero R-4 55