Lantronix 900-581 manual Navigating the CLI Hierarchy, Command Line Interface

3: Command Line Interface

To configure the Lantronix device server locally using a serial port:

1.Connect a terminal or a PC running a terminal emulation program to one of the device server's serial ports.

2.Configure the terminal to the following settings:

9600 baud

8-bit

No parity

1 stop bit

No flow control.

3.Power off the device.

4.Press and hold down the exclamation point (!) key.

5.Power on the device. After about 10 seconds, the exclamation point will display on the terminal or PC screen.

6.Type xyz within 5 seconds to display the CLI prompt.

Navigating the CLI Hierarchy

The CLI is organized into a hierarchy of levels. Each level has a group of commands for a specific purpose. For example, to configure a setting for the FTP server, one would navigate to the FTP level, which is under the configuration level.

To move to a different level—Enter the name of the level from within its parent level. For example, to enter the tunnel level, type tunnel <number> at the enable prompt. This displays: <enable> tunnel <number>#.

To exit and return to one level higher—Type exit and press the Enter key. Typing exit at the login level or the enable level will close the CLI session. If Line - Command Mode is specified as Always, a new session starts immediately.

To view the current configuration at any level—Type show.

To view the list of commands available at the current level—Type the question mark "?". Items within < > (e.g. <string>) are required parameters.

To view the available commands and explanations—Type the asterisk ( *).

To view the list of commands available for a partial command—Type the partial command followed by the question mark "?". For example: <tunnel-1>#show?displays a list of all echo commands at the tunnel level.

To view available commands and their explanations for a partial command—Type the partial command followed by the asterisk (*). For example: <tunnel-1>#show*displays a list of all echo commands and descriptions at the tunnel level.

To view the last 20 commands entered at the CLI—Type show history.

PremierWave EN Command Reference 10