ClearOne comm PRO 8I, PRO TH20 Type and Device IDs, Conventions, Command Form Description, 218

appendix a: serial command Guide

Type and Device IDs

Converge/Converge Pro Device Types and Device IDs by model are as follows:

Model	Device Type	Device ID Range
880	1	0-B
TH20	2	0-F
840T	3	0-B
8i	A	0-B
880T	D	0-B
880TA	H	0-B
SR 1212	G	0-B
SR 1212A	I	0-B

Conventions

This guide uses the following typographic conventions to describe Converge/Converge Pro serial command syntax:

Convention	Description
<X>	Parameters enclosed in < > indicate a mandatory parameter

[X]Parameters enclosed in [ ] indicate an optional parameter

1-8	Parameters separated by a ‘-‘ indicate a range of allowable values
4,7,9	Parameters separated by a ‘,’ indicate a list of allowable values
EREF	Words in UPPERCASE bold indicate command text
Device	Indicates the device type and device number on the Expansion Bus. It is
	composed of a device type character and a device ID character.

Command Form Description

The structure of serial commands is as follows:

#<Device Type> <Device ID> <Command> [Values] <Carriage Return>

#indicates the start of a command line, the Carriage Return terminates a command.

NOTE: Serial commands can be either UPPERCASE or lowercase. Return values are always in UPPERCASE. In order for a command to be recognized by the RS-232 serial port, the command must be terminated by a carriage return.

For example, a command to disable mute for Mic Input 5 on a Converge Pro 880 with a Device ID of 2 would have the command line #12 MUTE 5 M 0.

In this command line, 1 = the Device Type for Converge 880, 2 = the Device ID for unit 2, MUTE = serial command, 5 = the channel Value, M = the channel type Value for mic input channels, and 0 = the command Value that turns mute off.

If an asterisk (*) is placed in the Device Type or Device ID fields, the command will apply to all units or all devices respectively. For example, a command with a Device Type = 1 and a Device ID = * would apply the command to all Converge 880 units. A command with a Device Type = * and a Device ID = 6 would apply the command to all units with a Device ID of 6.

218