Signal Generator
The Signal Generator tab enables you to generate test signals to audibly test signal paths, gain settings, routing, and channel configuration settings. The signal generator can also be used for noise masking in courtroom, clergy, and corporate applications.
NOTE: When the signal generator is on for any unit in the site, the Signal Generator LED 
on the Console Button Bar flashes green.
Test Signal Types
The signal generator provides three types of test signals: Pink, White, and Tone.
•Pink Noise: A test signal containing all the frequencies in a given audio spectrum, with equal energy in each octave. Pink noise is the default signal.
•White Noise: A test signal with equal energy distribution throughout a given frequency range.
•Tone: A
•Linear Sweep Sine Wave: A test signal increasing in frequency using predefined steps.
•Log Sweep Sine Wave: A test signal increasing in frequency using exponential steps (rises on a curve).
Running a Signal Test
Use the following procedure to run a signal test:
1.Select the unit and channel to test using the unit and channel drop down lists.
2.Select the type of test tone using the Signal Selection slider.
3.Select the amplitude (volume) of the test tone using the Amplitude slider. The amplitude range is from
4.Set the level for the test tone using the dB entry field or up/down arrows.
5.Set desired test tone duration using the Signal Timeout entry field.
6.For Tone signals, set the additional Frequency settings as explained in the next section.
7.Press the Signal On button to initiate the test signal on the selected unit and channel. The signal will
