| 5: Commands and Levels |
|
|
auto show statistics | show connection statistics |
clear counters | Zeros all tunnel counters |
clrscrn | Clears the screen. |
connect | Enters the connect level for this tunnel. |
disconnect | Enters the disconnect level for this tunnel. |
exit | Exits to the enable level. |
line <line> | Enters the line level. |
| <line> = number of the line (serial port) to be configured. |
modem | Enters the modem level for this tunnel. |
no clear counters | Unzeros all tunnel counters |
packing | Enters the packing level for this tunnel. |
serial | Enters the serial level for this tunnel. |
show history | Displays the last 20 commands entered during the current CLI |
| session. |
show statistics | show connection statistics |
terminal <line> | Enters the |
| <line> = number of the terminal line (serial port) to be configured. |
terminal network | Enters the |
tunnel <line> | Enters the tunnel level. |
| <line> = number of the tunnel line (serial port) to be configured. |
write | Stores the current configuration in permanent memory. |
vip |
|
auto show counters | Displays VIP counters continuously. |
auto show status | Displays VIP status continuously. |
clear counters | Sets the VIP counters to zero. |
clrscrn | Clears the screen. |
exit | Exits to the configuration level. |
no clear counters | Restores the VIP counters to the aggregate values. |
show | Displays the current configuration. |
show counters | Displays the VIP counters. |
show history | Displays the last 20 commands entered during the current CLI |
| session. |
show status | Displays the VIP status. |
state disable | Disables use of Virtual IP (VIP) addresses. |
state enable | Enables use of Virtual IP (VIP) addresses. |
write | Stores the current configuration in permanent memory. |
|
|
wep | |
apply wlan | Try out WLAN settings without saving them to Flash. |
| If the settings do not work, when you reboot the device, |
| it will still have the original settings. |
authentication open | Sets the type of authentication to open. |
authentication shared | Sets the type of authentication to shared. |
clrscrn | Clears the screen. |
default authentication | Restores the authentication type to the default value (open). |
default key size | Restores the key size to the default value (40 bits). |
default tx key index | Restores the tx key index to the default value (1). |
PremierWave EN Command Reference | 207 |
