Lantronix 900-581 manual Command Line Interface, PremierWave EN Command Reference

3: Command Line Interface

Note: >To configure the PremierWave EN, you must be in the enable level and any of its sub-levels. Figure 3-4below shows the enable level commands.

Figure 3-4 Enable Level Commands
>enable
(enable)#?
auto show interfaces	auto show processes
clrscrn	configure
connect	connect line <line>
cpm	device
disable	dns
email <number>	exit
filesystem	kill ssh <session>
kill telnet <session>	line <line>
ping <host>	ping <host> <count>
ping <host> <count> <timeout>	reload
reload factory defaults	show
show history	show interfaces
show ip sockets	show lines
show processes	show sessions
ssh	ssh <optClientUsername> <host>
ssh <optClientUsername> <host> <port>	ssl
telnet <host>	telnet <host> <port>
trace route <host>	tunnel <line>
write	xml

<enable>#

See the Chapter 5: Commands and Levels at the end of this document for a complete list of levels, commands, and descriptions.

PremierWave EN Command Reference 13