Lantronix 900-581 manual Commands and Levels, PremierWave EN Command Reference

	5: Commands and Levels
no email connect	Discontinues sending email alerts upon establishing a connect
	mode tunnel.
no email disconnect	Discontinues sending email alerts upon closing a connect mode
	tunnel.
promote host <number>	Promotes the identified host, exchanging it place with the host
	above it,
	to adjust the order of the defined hosts.
reconnect time <milliseconds>	Sets the reconnect time value for tunneling connections estab-
	lished by the
	device in milliseconds.
	<milliseconds> = timeout in milliseconds.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
show status	Displays tunnel connect status.
start character <control>	Sets the connect mode start character.
	The character may be input as text, control, decimal, or hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
write	Stores the current configuration in permanent memory.
cp (email-cp:16) level commands
clrscrn	Clears the screen.
exit	Exits to the next higher level.
group <text>	Specify a CP group that shall trigger an email.
	<text> = configurable pin group.
no group	Disables the trigger to send an email.
no trigger value	Clears the value that shall trigger an email.
show	Shows the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
trigger value <number>	Specify a value of the CP group that shall trigger an email.
	<number> = numeric value to watch for from the CP group. Can
	be specified as
	hex if prepended with “0x”.
write	Stores the current configuration in permanent memory.
cp (email-cp:15) level commands
clrscrn	Clears the screen.
exit	Exits to the next higher level.
group <text>	Specify a CP group that shall trigger an email.
	<text> = configurable pin group.
no group	Disables the trigger to send an email.
no trigger value	Clears the value that shall trigger an email.
show	Shows the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
trigger value <number>	Specify a value of the CP group that shall trigger an email.
	<number> = numeric value to watch for from the CP group. Can
	be specified as
	hex if prepended with “0x”.

PremierWave EN Command Reference 65