| 5: Commands and Levels |
|
|
| <number> = the number of the email profile to use. |
email disconnect <number> | Sets an email profile to use to send an email alert upon closing |
| a connect mode tunnel. |
| <number> = the number of the email profile to use. |
exit | Returns to the tunnel level. |
flush serial disable | Characters already in the serial data buffer are retained upon es- |
| tablishing |
| a connect mode tunneling connection. |
flush serial enable | Flushes the serial data buffer upon establishing a connect mode |
| tunneling |
| connection. |
flush start character disable | Enables forwarding of the connect start character into the net- |
| work. |
flush start character enable | Disables forwarding of the connect start character into the net- |
| work. |
host <instance> | Enters the next lower level. |
| Specify the instance for the next lower level. |
host mode sequential | Connects to the first host in the list that accepts the connection. |
host mode simultaneous | Selects simultaneous connections to all hosts on the host list. |
kill connection | Disconnects the active connect mode tunneling connection or |
| connections. |
local port <number> | Sets a specific port for use as the local port. |
| <number> = the number of the port to use. |
no email connect | Discontinues sending email alerts upon establishing a connect |
| mode tunnel. |
no email disconnect | Discontinues sending email alerts upon closing a connect mode |
| tunnel. |
promote host <number> | Promotes the identified host, exchanging it place with the host |
| above it, |
| to adjust the order of the defined hosts. |
reconnect time <milliseconds> | Sets the reconnect time value for tunneling connections estab- |
| lished by the |
| device in milliseconds. |
| <milliseconds> = timeout in milliseconds. |
show | Displays the current configuration. |
show history | Displays the last 20 commands entered during the current CLI |
| session. |
show status | Displays tunnel connect status. |
start character <control> | Sets the connect mode start character. |
| The character may be input as text, control, decimal, or hex. |
| A control character has the form <control>C. |
| A decimal value character has the form \99. |
| A hex value character has the form 0xFF. |
write | Stores the current configuration in permanent memory. |
connect |
|
block network disable | Forwards (tunnels) network data in connect mode tunneling. |
block network enable | Discards all data coming in from the connect mode tunnel before |
| forwarding |
| it to the serial interface (generally used for debugging). |
block serial disable | Forwards (tunnels) serial data in connect mode tunneling. |
block serial enable | Discards all data coming in from the serial interface before for- |
PremierWave EN Command Reference | 63 |
