Lantronix 900-581 Arp config-arp level commands, Add IP address MAC address, Remove ip IP address

	5: Commands and Levels
tx data rate maximum mcs1	Sets the data rate maximum to MCS1.
tx data rate maximum mcs2	Sets the data rate maximum to MCS2.
tx data rate maximum mcs3	Sets the data rate maximum to MCS3.
tx data rate maximum mcs4	Sets the data rate maximum to MCS4.
tx data rate maximum mcs5	Sets the data rate maximum to MCS5.
tx data rate maximum mcs6	Sets the data rate maximum to MCS6.
tx data rate maximum mcs7	Sets the data rate maximum to MCS7.
tx power maximum <dBm>	Sets the TX power maximum in dBm.
	<dBm> = measure of power in decibels with respect to one
	milliwatt.
write	Stores the current configuration in permanent memory.
arp (config-arp) level commands
add <IP address> <MAC address>	Adds an entry to the ARP table, mapping an IP address to a MAC
	address.
	<ip address> = IP address to be mapped.
	<mac address> = MAC address in colon-separated form.
clrscrn	Clears the screen.
exit	Exits to the configuration level.
remove all	Removes all entries from the ARP cache.
remove ip <IP address>	Removes an entry from the ARP cache.
	<ip address> = address of the entry being removed.
show cache	Displays the ARP cache table.
show history	Displays the last 20 commands entered during the current CLI
	session.
write	Stores the current configuration in permanent memory.
bridge 1 (config-bridge:br0) level commands
bridging mac address <hexadecimal>	Sets the Bridging MAC Address.
	Each byte is represented by two adjacent hex digits.
	Bytes may run together or be separated by optional punctuation:
	123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
	Note that quotes must enclose the value if it contains spaces.
clrscrn	Clears the screen.
exit	Exits to the config level.
no bridging mac address	Removes the Bridging MAC Address.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
show statistics	Show bridge statistics
show status	Show bridge status
state disable	Disables bridging.
state enable	Enables bridging.
write	Stores the current configuration in permanent memory.
choice 1 (config-wlan-choice:wlan0:1) level commands
apply wlan	Try out WLAN settings without saving them to Flash.
	If the settings do not work, when you reboot the device,
	it will still have the original settings.
clrscrn	Clears the screen.
exit	Exits to the next higher level.

PremierWave EN Command Reference 57