
| 5: Commands and Levels |
|
|
key 4 | |
apply wlan | Try out WLAN settings without saving them to Flash. |
| If the settings do not work, when you reboot the device, |
| it will still have the original settings. |
clrscrn | Clears the screen. |
exit | Exits to the next higher level. |
key <hexadecimal> | Sets key. |
| Each byte is represented by two adjacent hex digits. |
| Bytes may run together or be separated by optional punctuation: |
| 123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc |
| Note that quotes must enclose the value if it contains spaces. |
key text <text> | Sets key. |
| Each byte is represented by a single character. |
| Note that quotes must enclose the value if it contains spaces. |
no key | Removes key. |
show | Shows the current configuration. |
show history | Displays the last 20 commands entered during the current CLI |
| session. |
write | Stores the current configuration in permanent memory. |
key 4 | adhoc_profile:4) level commands |
apply wlan | Try out WLAN settings without saving them to Flash. |
| If the settings do not work, when you reboot the device, |
| it will still have the original settings. |
clrscrn | Clears the screen. |
exit | Exits to the next higher level. |
key <hexadecimal> | Sets key. |
| Each byte is represented by two adjacent hex digits. |
| Bytes may run together or be separated by optional punctuation: |
| 123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc |
| Note that quotes must enclose the value if it contains spaces. |
key text <text> | Sets key. |
| Each byte is represented by a single character. |
| Note that quotes must enclose the value if it contains spaces. |
no key | Removes key. |
show | Shows the current configuration. |
show history | Displays the last 20 commands entered during the current CLI |
| session. |
write | Stores the current configuration in permanent memory. |
|
|
line 1 (line:1) level commands |
|
auto show statistics | Continuously displays line statistics. |
baud rate <bits per second> | Sets the line speed. |
| <bits per second> = the speed. |
| Standard speeds include 1200, 2400, 4800, 9600, 19200, and so |
| on. |
clear line counters | Sets the serial counters to zero. |
clrscrn | Clears the screen. |
command mode always | Sets the current line to always be in command mode. |
command mode echo serial string disable | Disables |
command mode echo serial string enable | Enables |
command mode serial string | Enables user to enter a custom string at boot time to enter com- |
PremierWave EN Command Reference | 183 |