Lantronix 900-581 Log config-diagnostics-log level commands, Modem tunnel-modem3 level commands

	5: Commands and Levels
duplex half	Sets duplex mode to half.
exit	Exit back to interface configuration level
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
speed 10	Sets the speed of the Ethernet link to 10 Mbps.
speed 100	Sets the speed of the Ethernet link to 100 Mbps.
speed auto	Sets the speed of the Ethernet link to auto-negotiate.
write	Stores the current configuration in permanent memory.
log (config-diagnostics-log) level commands
clrscrn	Clears the screen.
default max length	Restores the factory default maximum Log file size.
default output	Restores the default log output, which is disable.
exit	Exits to the next higher level.
max length <Kbytes>	Sets the maximum size in Kbytes for the Log file.
output disable	Disables log output.
output filesystem	Enables log to filesystem.
output line <number>	Enables log to serial line.
show	Shows the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
write	Stores the current configuration in permanent memory.
modem (tunnel-modem:3) level commands
clrscrn	Clears the screen.
connect string <text>	Sets the CONNECT string used in modem emulation.
	<string> = connect string.
default incoming connection	Default disables incoming network connections.
default response type	Default uses text type responses.
display remote ip disable	The incoming RING has nothing following it.
display remote ip enable	The incoming RING is followed by the IP address of the caller.
echo commands disable	Does not echo modem commands.
echo commands enable	Echoes modem commands.
echo pluses disable	Does not echo the +++ characters when entering modem com-
	mand mode.
echo pluses enable	Echoes the +++ characters when entering modem command
	mode.
error unknown commands disable	Returns OK on unknown AT commands.
error unknown commands enable	Returns an error upon unknown AT commands.
exit	Returns to the tunnel level.
incoming connection automatic	Automatically answer incoming network connections.
incoming connection disabled	Disable incoming network connections.
incoming connection manual	Wait for an ATA command before answering an incoming network
	connection.
no connect string	Removes optional CONNECT string information for modem emu-
	lation.
reassert	Asserts tunnel modem status with current configured values.

PremierWave EN Command Reference 191