| 5: Commands and Levels |
|
|
dns | Enters the DNS level. |
email <number> | Enters the configure email level. |
exit | Exit from the system |
filesystem | Enters the filesystem level. |
iperf <params> | Run iperf with command line parameters passed in quoted string. |
kill ssh <session> | Kills SSH session with index from "show sessions" |
kill telnet <session> | Kills Telnet session with index from "show sessions" |
line <line> | Enters the line level. |
| <line> = number of the line (serial port) to be configured. |
ping <host> | Ping destination continuously with 5 second timeout |
ping <host> <count> | Ping destination n times with 5 second timeout |
ping <host> <count> <timeout> | Ping destination n times with x timeout (in seconds) |
reload | Reboot system |
reload factory defaults | Reload factory defaults to permanent storage |
show | Show system information |
show history | Displays the last 20 commands entered during the current CLI |
| session. |
show interfaces | Show interface statistics |
show ip sockets | Show UDP/TCP state information |
show lines | Show line information |
show processes | Show thread runtime information |
show sessions | Show active Telnet and SSH Sessions |
ssh | Enters the SSH configuration level. |
ssh <optClientUsername> <host> | Begin SSH session on network <host>. |
| The optClientUserName must match an SSH Client: Users con- |
| figuration entry. |
| Use "" in optClientUserName to prompt for host username and |
| password. |
ssh <optClientUsername> <host> <port> | Begin SSH session on network <host>:<port>. |
| The optClientUserName must match an SSH Client: Users con- |
| figuration entry. |
| Use "" in optClientUserName to prompt for host username and |
| password. |
ssl | Enters the SSL configuration level. |
telnet <host> | Begin telnet session on network <host>. |
telnet <host> <port> | Begin telnet session on network <host>:<port>. |
trace route <host> | Trace route to destination |
trace route <host> <protocol> | Trace route to destination using TCP, ICMP, or UDP |
tunnel <line> | Enters the tunnel level. |
| <line> = number of the tunnel line (serial port) to be configured. |
write | Stores the current configuration in permanent memory. |
xml | Enters the XML level. |
filesystem (filesystem) level commands |
|
cat <file> | Show the contents of a file |
cd <directory> | Change the current directory to the specified directory |
clrscrn | Clears the screen. |
cp <source file> <destination file> | Copy an existing file |
PremierWave EN Command Reference | 96 |
