Lantronix 900-581 manual Ip config-ip level commands, Key hexadecimal

	5: Commands and Levels
	192.168.1.1/24 (CIDR)
	"192.168.1.1 255.255.255.0" (explicit mask)
link	Enter link configuration level
mtu <bytes>	Sets the Maximum Transmission Unit (MTU) size.
no default gateway	Clears the default gateway.
no dhcp client id	Clears the DHCP client ID.
no domain	Clears the domain name.
no hostname	Clears the host name.
no ip address	Clears the IP address.
no primary dns	Clears the name of the primary DNS server.
no secondary dns	Clears the name of the secondary DNS server.
primary dns <IP address>	Sets the IP address of the primary DNS server.
secondary dns <IP address>	Sets the IP address of the secondary DNS server.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
show status	Show interface status
state disable	Disables the interface.
state enable	Enables the interface.
write	Stores the current configuration in permanent memory.
ip (config-ip) level commands
clrscrn	Clears the screen.
default ip time to live	Restores the default IP time to live.
default multicast time to live	Restores the default IP multicast time to live, which is one hop.
exit	Exits to the configuration level.
ip time to live <hops>	Sets the IP time to live, known by SNMP as "ipDefaultTTL".
	<hops> = number of hops that a typical IP packet is allowed to
	live.
multicast time to live <hops>	Sets the IP multicast time to live.
	<hops> = number of hops that a multicast IP packet is allowed to
	live.
show	Displays the current configuration.
show history	Displays the last 20 commands entered during the current CLI
	session.
write	Stores the current configuration in permanent memory.
key 1 (config-profile-security-wep-key:test1:1)	level commands
apply wlan	Try out WLAN settings without saving them to Flash.
	If the settings do not work, when you reboot the device,
	it will still have the original settings.
clrscrn	Clears the screen.
exit	Exits to the next higher level.
key <hexadecimal>	Sets key.
	Each byte is represented by two adjacent hex digits.
	Bytes may run together or be separated by optional punctuation:
	123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
	Note that quotes must enclose the value if it contains spaces.
key text <text>	Sets key.
	Each byte is represented by a single character.

PremierWave EN Command Reference 180