Appendix H: Diamond Shield Removal and Installation, continued
3.Release the six clips that hold the Diamond Shield in place. Work on one side at a time, starting with the top clip. Follow these steps:
(1)Refer to figure 4. Hold the plastic card vertically, angled slightly toward the middle of the screen.
(2)Insert the card into the channel, alongside the clip.
(3)Refer to figure 5. While keeping the card pressed in on the clip, angle the card outward, away from the middle of the screen, and pry out the clip.
WARNING
Sharp edges! Always wear gloves to handle, lift, install, and remove the Diamond shield.
4.When all clips are released, lift the shield up out of the lower channel and away from the TV.
5.Store the Diamond Shield protected from scratches in a clean,
Notched edge
down
Figure 6. Center the trim piece, notched side down, and set it in the channel below the screen.
TV Screen | Trim Piece |
Raised Lip
Channel
Figure 7. The lower trim piece fits snugly into the channel and over the raised lip that runs along the bottom of the TV screen.
Top View | Top View | ||
|
|
|
|
|
|
|
|
|
|
|
|
Note
Angle
of Card
Diamond Shield
Clip
Angle card toward shield before inserting
Figure 4. To release | Figure 5. Pry the clip out |
the clip, insert the card | of the channel. |
alongside the clip at the |
|
angle shown. |
|
Install Trim
Note: Install the trim pieces in the order described here.
6.Install the lower trim piece as follows:
(1)Center the trim piece in front of the TV, notched edge down, and set it in the channel below the screen. See figure 6.
(2)Refer to figure 7. With the trim piece resting in the channel, hook the trim piece onto the raised lip at the bottom edge of the TV screen.
To do this,
a.Gently press the trim piece against the TV frame.
b.Push the trim up slightly to clear the raised lip.
c.Press down firmly on the top edge of the trim piece to push it snugly into place over the raised lip and into the channel. Be sure to press along the entire length of the trim to fully seat it.
112Appendices