Mitsubishi Electronics WD-62827 manual Appendix a Specifications, TV Specifications, Inputs

Page 98

Appendix A: Specifications

From time to time, Mitsubishi may offer software updates to expand the features or operation of this TV. When these updates are available they will be announced on our web site, Mitsubishi-tv.com. If you return your owner’s registration card, with your model and serial number, you may receive written notification of available software updates.

TV Specifications

 

 

 

 

Projection System

DLP, 0.843” chip, 1920 x 1080 pixels with Smooth Picture™

 

 

Lamp

150-watt VIP type

 

 

Channel Frequency Reception

Over-the-Air: VHF 2–13, UHF 14–69

 

Analog Cable: 1–125

 

Digital Cable: 1–135

 

 

 

Channel Type

Over the Air:

Analog NTSC, Digital ATSC with sub-channels (all 18 video

 

 

formats)

 

Cable:

Analog NTSC (non-scrambled)

 

 

Digital QAM 64 and 256 with sub-channels (non-

 

 

scrambled)

 

CableCARD™: Authorized scrambled and non-scrambled digital

 

 

channels

 

 

 

Note for Digital Channels: The channel numbers displayed on screen are determined by the broadcaster or cable company and can vary from the standard frequency number. If there is no channel number information included from the broadcaster or cable company, then the TV will create a channel number based on the frequency number as the

main channel number and the program number as the sub-channel number. When using an authorized CableCARD,

the channel numbers are determined by the cable company.

 

 

 

Inputs

 

 

Antenna/Cable input Qty. 2

F connector, 75-ohm

 

 

HDMI (digital video/audio), Qty. 2

HDMI standard connector

Signal Type

HDMI EIA-861B standard for digital audio and video.

 

Video: 480i, 480p, 720p, 1080i

 

Audio: PCM stereo

 

HDMI 1: Not intended for use with personal computers.

 

HDMI 2: Accepts PC input.

 

VGA (640 x 480), 60-Hz

 

W-VGA (848 x 480), 60-Hz

 

SVGA (800 x 600), 60-Hz

 

W-SVGA (1064 x 600), 60-Hz

 

XGA (1024 x 768), 60-Hz

 

1280 x 720, 60-Hz (EIA standards)

 

 

 

Video/S-Video, Qty. 3 each

Video:

RCA Pin Plug, 1.0 V p-p, 75 ohm

(1 front, 2 rear)

S-Video: Four-Pin DIN Plug

 

 

Y: 1.0 Vp-p 75-ohm

 

 

C: 0.286 Vp-p (burst signal), 75-ohm

Signal Type

NTSC 480i only

 

 

Component Video (Y/Pr/Pb), Qty. 3 sets

RCA Pin Plug (EIA-770.3 Standard Levels and Timing)

 

Y:

1.0 Vp-p (includes sync), 75-ohm

 

Pr:

700 mV p-p, 75-ohm

 

Pb:

700 mV p-p, 75-ohm

Signal Type

EIA-770.1 & EIA 770.2 480i, 480p, EIA 770.3 720p and 1080i (video standards)

 

 

Audio Inputs: Qty. 8 pairs

RCA Pin Plug 500 mV (full scale), 43-k ohm

 

 

 

98Appendices

Image 98
Contents Visit our website at TV InformationStand Requirement TV Guide On Screen Access RequirementsWhile Under Warranty After Warranty TV Model Number Stand Model NumberFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Our Thanks Mitsubishi Digital Electronics America, IncChapter TV Accessories      Special Features of Your TV TV Guide On Screen Interactive Program Guide System Widescreen Picture FormatMemory Card Reader Card Compatibility Memory Card Reader and Front-Panel InputsInput 3 and Ieee 1394 Input/Output Front Control Panel ResetFront-Panel Indicator Lights Lamp Indicator Status Indicator Power/Timer IndicatorRemote Control OverviewCare Battery InstallationSleep Timer Input 1 IR Emitter NetCommandTV Back Panel . Component 1-3 InputsMonitorLink/RS-232C Control DVI Analog AudioHdmi 1 DTVLink/IEEEDemo Track System Reset ButtonAdditional Information Connecting Connecting External Devices and NetCommand Setup Audio cablesStandard Cable Box Connecting a Wall Outlet Cable or Cable BoxWall Outlet Cable Can be used with a CableCARDFor antennas with flat twin leads Antenna with a Single LeadAntennas with Separate UHF and VHF Leads For cable or antenna with coaxial leadVCR to an Antenna or Wall Outlet Cable Audio & Video $3CBDLQBOFMConnecting a VCR to a Cable Box Audio & Video VCR to a Cable Box Audio & VideoTo connect an analog A/V receiver Receiver Stereo SystemSatellite Receiver or Other Device with S-Video DVI Device See Appendix a for component video signalDVD Player with Component Video Hdtv Cable Box or Satellite Receiver with Component Video Hdmi DeviceConnecting a MonitorLink Control/RS-232C Device MonitorLink Control/RS-232C DeviceConnecting the IR Emitter NetCommand TJFEEFWJDFTConnection Styles Connecting Compatible Ieee 139 Devices-Pin-Style vs -Pin-Style Connectors Direct Device-To-Device StyleDigital Audio Signals When Connecting Ieee 139 DevicesDigital Video Signals Digital Control SignalHelpful Hints for NetCommand Connections NetCommand Setup and Editing NetCommand Introduction Receiver Cable Box SAT Satellite DVD Player Using the Remote Control with NetCommandNetCommand Pre-Memorized Devices ReceiverNetCommand Setup On-Screen Buttons Remote Control Buttons 3D Graphical Menu SystemWelcome Screen NetCommand Initial SetupNetCommand Information Screen Device Setup Screen Review Screen NetCommand Initial Setup, Setup ReminderSetup Reminder Finish ScreenReceiver Inputs Edit NetCommand Adding an A/V ReceiverReceiver Screen Receiver AVR Input Learn Screen Receiver AVR Learn ScreenName Screen Audio Output to AVR ScreenNew Device Screen Edit NetCommand Adding DevicesEdit NetCommand Screen Device Screen Device Learn ScreenDevice Advanced Learn Screen Connection for Device ScreenRF Connection for Cable Screen VCR for Recordings ScreenIR Code for Device Screen Delete Device Screen Edit NetCommand Changing or Deleting DevicesChange Device Screen Ieee 1394 Devices and NetCommand Control New 1394 Device Screen Name for 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically Connection Screen Adding Ieee 139 Devices AutomaticallyIeee 139 Device Type Screen Page NetCommand Functions Audio Section Device Selection MenuPIP Device Selection Menu Video SectionCableCARD Menu Using the Device Menu Button to Display MenusDevice Menu IR Controlled DevicesGuide Button Using the Guide Button to Display ChannelView and MenusGuide and the Recording Setup Screen Guide and the Device Selection MenuTime-Delayed Recording NetCommand-Controlled RecordingsSetting up Recordings Record ListTV Disc and A/V Disc Track List Screen Direct VCR Recording from an Antenna or Cable SourceTV Disc and A/V Disc Search by Time Copy-Protected MaterialCopying or Moving TV Disc or A/V Disc Recordings Using TV Disc and A/V DiscsUsing the Remote Control with TV Disc or an A/V Disc Cancelling a Peer-to-Peer Connection What is a Peer-to-Peer Connection?Setting up a Non-Recording Peer-to- Peer Connection Peer-to-Peer ConnectionsTV Menu Operations Main Menu Memorize Channels Setup MenuLanguage ClockSoftware Version TimerLamp Reminder Edit NetCommand MenuRemote Control Transport Buttons Icon OrderControlling TV Pause Features TV PauseTimeShuttle and TV Disc Recordings TimeShuttleTV Pause with TimeShuttle To Turn Off TimeShuttleRecord Menu Recording SetupTime-Delayed Recording RecordTV Guide On Screen and the Record List Default Digital Record DeviceCancel Scheduled Recordings Analog RecordingsChannel Menu Signal Strength SQV SuperQuickViewAnalog Captions Digital SettingsCaptions Menu BackgroundColor FontsSize Opacity FontChip Lock Menu Setting a Pass CodeSetting V-Chip Options Chip Lock Menu OverviewFront Button Lock V-CHIP ButtonLock by Time Bypassing V‑Chip Lock and Lock by TimeChip Ratings Chip Signal InformationContent Categories Audio/Video Menu Analog-Only Audio Settings Audio SettingsAnalog and Digital Audio Settings Digital-Only Audio SettingsPC Video Settings Video SettingsVideo Settings Page MediaCommand and Memory Card Playback CableCARDCableCARD Technology Using a CableCARDCableCARD MediaCommand and Memory Card Playback Memory Card SlotsFor Jpeg Picture Slide Show Setup Media Command and Memory Card PlaybackMedia Setup Menu For MP3 or WMA Audio Playlist SetupOperation of PIP and POP DVD Definitions Signal DefinitionsTV Display Formats Format Definitions57%JTQMBZ Digital Program On-Screen InformationAnalog Program TV Disc or Digital Ieee 1394 DeviceUsing the TV with a PC Computer with an Hdmi Monitor Output Connecting a PCSee Appendix a for signal compatibility Models WD-62927 and WD-73927 Computer with a DVI Monitor OutputComputer with a 15-Pin Monitor Output Adjusting Image Resolution Adjusting Image ResolutionPC Display Formats Page Appendix J Troubleshooting Appendix a SpecificationsAppendix F Cleaning and Service Inputs Appendix a SpecificationsTV Specifications Outputs Appendix B NetCommand Specialized Device Keys Bypassing the V-Chip Lock Appendix CBypassing the V-Chip Lock Deactivating the Front Button LockThis page intentionally blank Receivers Appendix D Remote Control Programming CodesProgramming the Remote to Control NetCommand A/V Products Cable BoxesVCRs DVD PlayersSatellite Receivers/SAT/DTV VCR position TV positionCable/SAT/DTV position DVD positionAppendix E Device Control with NetCommand NetCommand Compatible Traditional Devices AnalogWhen an Ieee 1394 Device is Viewed or Played Ieee 1394 DevicesAppendix F Cleaning and Service Appendix G Lamp Cartridge Replacement Do not touch the glass parts of the lamp cartridgeWash Your Hands THOROUGHLY, AS this Lamp Contains Mercury Appendix H Diamond Shield Removal and Installation See detailTV Screen Install TrimNotched edge Down Raised Lip ChannelStep Hook the lower End over Raised lip Install the Diamond ShieldStep Hook the top End over Raised lip Pry up from the notches at both endsDigital VCR or A/V Disc Connected to IEEE-1394 Port Appendix I Recording and Viewing CombinationsAnalog VCR Connected to Audio and Video Record Outputs General TV Operation Appendix J TroubleshootingSymptom Remarks PIP Indicators PictureSound RecordingExcessive digital artifacts when viewing an Ieee TV Guide On Screen Trademark and License Information Mitsubishi TV Software Mitsubishi DLP Projection Television Limited Warranty 123This Limited Warranty does not Cover 124Index IndexIndex Page MDEAservice@mdea.com Website Mail
Related manuals
Manual 86 pages 7.9 Kb