Mitsubishi Electronics WD-62827 manual Mitsubishi DLP Projection Television Limited Warranty, 123

Page 123

Mitsubishi DLP™ Projection Television Limited Warranty

MITSUBISHI DIGITAL ELECTRONICS AMERICA, INC. (“MDEA”) warrants as follows to the original purchaser of this television from an authorized MITSUBISHI Audio/Video Dealer, should it prove defective by reason of against defects arising from improper workmanship and/or material:

a. Parts. The lenticular (i.e. front picture) screen is warranted against defects in materials and workmanship for a period of thirty (30) days from the date of the original purchase at retail. The lamp and all other parts (except any software incorporated into this television) are warranted for a period of one (1) year from the date of the original purchase at retail. We will repair or replace, at our option, any defective part without charge for the part. Parts used for replacement may be replaced with those of like kind and quality and may be new or remanufactured. Parts used for replacement are warranted for the remainder of the original warranty period.

b. Embedded Software. MDEA warrants that all software incorporated into this television set (the “Embedded Software”) will perform in accordance with the functional description of Embedded Software in all material respects, but MDEA does not warrant that the Embedded Software is error-free. MDEA also does not warrant that the Embedded Software will be compatible under IEEE 1394 AV/C and HAVi software standards with products produced by any other manufacturer. The limited warranty contained in this section shall continue for a period of one (1) year from the date of the original purchase at retail. If, after prompt notice within the warranty period, MDEA determines that the Embedded Software has failed to perform in accordance with such functional description in all material respects and if such failure is not due to accident, misuse, modification or misapplication of the Embedded Software, then MDEA shall modify or replace the nonconforming Embedded Software at no charge to you, which at MDEA’s sole discretion may be fulfilled by means of modification or replacement software contained on a replacement memory card for Customer installation. The foregoing shall be MDEA’s sole obligation to you under this limited warranty. All rights under this limited warranty on the Embedded Software also subject to your acceptance of and compliance with the terms of the Software License Agreement applicable to this television, and this limited warranty on the Embedded Software shall be null and void if the Embedded Software is modified or changed in any manner except as specifically authorized by MDEA.

c. Labor. For thirty (30) days after the original purchase at retail, we will repair or replace, at our option, the lenticular screen if it proves defective. For certain items that are designed to be replaced by the consumer, including (but not limited to) some Embedded Software, the consumer is solely responsible for any replacement labor. For all other parts, we will provide the labor for a warranty repair by an authorized MITSUBISHI service center without charge for one (1) year from the original date of purchase at retail.

d. Notice. To obtain warranty service, you must notify an authorized MITSUBISHI service center of any defect within the applicable warranty time period.

e. This DLP Projection Television uses a single DLP chip to create the screen image. This technology creates the image using small dots, or picture elements (pixels). Your DLP Projection TV is manufactured to a high level of performance and quality, in fact, 99.99% perfect in the number of properly functioning pixels. As in other display technology, sometimes a pixel is continuously active, inactive or the incorrect color. Our standard is clear; MDEA warrants only that the percentage of properly functioning pixels will be not less than 99.99% of all pixels.

BEFORE REQUESTING SERVICE, please review the instruction booklet to insure proper installation and correct customer control adjustment. If the problem persists please arrange for warranty service.

1. TO OBTAIN WARRANTY SERVICE:

a. Contact your nearest authorized MITSUBISHI service center, whose name and address can be obtained from your MITSUBISHI dealer, by writing at the address provided below, calling MDEA at the 800-332-2119, or by using the support feature of our website at www.Mitsubishi-tv.com.

b. Warranty service will be provided in your home or, if required, at an authorized service shop, provided that your television is located within the geographic territory customarily covered by an authorized MITSUBISHI service center. If not, you must either deliver your television to an authorized service location at your own expense, or pay for any travel and/or transportation costs the service center may charge to and from your home. Actual service labor will be provided without charge.

c. Proof of purchase date from an authorized MITSUBISHI dealer is required when requesting warranty service. Present your sales receipt or other document which establishes proof and date of purchase. THE RETURN OF THE OWNER REGISTRATION CARD IS NOT A CONDITION OF COVERAGE UNDER THIS LIMITED WARRANTY. However, please return the Owner Registration Card so that we can contact you should a question of safety arise which could affect you.

123

Image 123
Contents TV Information Visit our website atTV Model Number Stand Model Number TV Guide On Screen Access RequirementsWhile Under Warranty After Warranty Stand RequirementFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics America, Inc Our ThanksChapter       TV AccessoriesSpecial Features of Your TV Widescreen Picture Format Memory Card ReaderTV Guide On Screen Interactive Program Guide System Memory Card Reader and Front-Panel Inputs Input 3 and Ieee 1394 Input/OutputCard Compatibility Reset Front-Panel Indicator Lights Lamp IndicatorFront Control Panel Power/Timer Indicator Status IndicatorOverview Remote ControlBattery Installation Sleep TimerCare . Component 1-3 Inputs IR Emitter NetCommandTV Back Panel Input 1DTVLink/IEEE DVI Analog AudioHdmi 1 MonitorLink/RS-232C ControlSystem Reset Button Additional InformationDemo Track Connecting Audio cables Connecting External Devices and NetCommand SetupCan be used with a CableCARD Connecting a Wall Outlet Cable or Cable BoxWall Outlet Cable Standard Cable BoxFor cable or antenna with coaxial lead Antenna with a Single LeadAntennas with Separate UHF and VHF Leads For antennas with flat twin leads$3CBDLQBOFM VCR to an Antenna or Wall Outlet Cable Audio & VideoVCR to a Cable Box Audio & Video Connecting a VCR to a Cable Box Audio & VideoReceiver Stereo System Satellite Receiver or Other Device with S-VideoTo connect an analog A/V receiver See Appendix a for component video signal DVD Player with Component VideoDVI Device Hdmi Device Hdtv Cable Box or Satellite Receiver with Component VideoMonitorLink Control/RS-232C Device Connecting a MonitorLink Control/RS-232C DeviceTJFEEFWJDFT Connecting the IR Emitter NetCommandDirect Device-To-Device Style Connecting Compatible Ieee 139 Devices-Pin-Style vs -Pin-Style Connectors Connection StylesDigital Control Signal When Connecting Ieee 139 DevicesDigital Video Signals Digital Audio SignalsHelpful Hints for NetCommand Connections NetCommand Setup and Editing NetCommand Introduction Receiver Using the Remote Control with NetCommandNetCommand Pre-Memorized Devices Receiver Cable Box SAT Satellite DVD PlayerNetCommand Setup On-Screen Buttons 3D Graphical Menu System Remote Control ButtonsNetCommand Initial Setup NetCommand Information ScreenWelcome Screen Device Setup Screen Finish Screen NetCommand Initial Setup, Setup ReminderSetup Reminder Review ScreenEdit NetCommand Adding an A/V Receiver Receiver ScreenReceiver Inputs Receiver AVR Learn Screen Receiver AVR Input Learn ScreenAudio Output to AVR Screen Name ScreenEdit NetCommand Adding Devices Edit NetCommand ScreenNew Device Screen Device Learn Screen Device ScreenConnection for Device Screen Device Advanced Learn ScreenVCR for Recordings Screen IR Code for Device ScreenRF Connection for Cable Screen Edit NetCommand Changing or Deleting Devices Change Device ScreenDelete Device Screen Ieee 1394 Devices and NetCommand Control Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyNew 1394 Device Screen Name for 1394 Device Screen Adding Ieee 139 Devices Automatically Ieee 139 Device Type ScreenConnection Screen Page NetCommand Functions Video Section Device Selection MenuPIP Device Selection Menu Audio SectionIR Controlled Devices Using the Device Menu Button to Display MenusDevice Menu CableCARD MenuGuide and the Device Selection Menu Using the Guide Button to Display ChannelView and MenusGuide and the Recording Setup Screen Guide ButtonRecord List NetCommand-Controlled RecordingsSetting up Recordings Time-Delayed RecordingCopy-Protected Material Direct VCR Recording from an Antenna or Cable SourceTV Disc and A/V Disc Search by Time TV Disc and A/V Disc Track List ScreenUsing TV Disc and A/V Discs Using the Remote Control with TV Disc or an A/V DiscCopying or Moving TV Disc or A/V Disc Recordings Peer-to-Peer Connections What is a Peer-to-Peer Connection?Setting up a Non-Recording Peer-to- Peer Connection Cancelling a Peer-to-Peer ConnectionTV Menu Operations Main Menu Clock Setup MenuLanguage Memorize ChannelsTimer Lamp ReminderSoftware Version Icon Order NetCommand MenuRemote Control Transport Buttons EditTV Pause Controlling TV Pause FeaturesTo Turn Off TimeShuttle TimeShuttleTV Pause with TimeShuttle TimeShuttle and TV Disc RecordingsRecord Recording SetupTime-Delayed Recording Record MenuAnalog Recordings Default Digital Record DeviceCancel Scheduled Recordings TV Guide On Screen and the Record ListChannel Menu SQV SuperQuickView Signal StrengthBackground Digital SettingsCaptions Menu Analog CaptionsOpacity Font FontsSize ColorChip Lock Menu Overview Setting a Pass CodeSetting V-Chip Options Chip Lock MenuBypassing V‑Chip Lock and Lock by Time V-CHIP ButtonLock by Time Front Button LockChip Signal Information Content CategoriesChip Ratings Audio/Video Menu Digital-Only Audio Settings Audio SettingsAnalog and Digital Audio Settings Analog-Only Audio SettingsVideo Settings Video SettingsPC Video Settings Page CableCARD MediaCommand and Memory Card PlaybackUsing a CableCARD CableCARDCableCARD Technology Memory Card Slots MediaCommand and Memory Card PlaybackFor MP3 or WMA Audio Playlist Setup Media Command and Memory Card PlaybackMedia Setup Menu For Jpeg Picture Slide Show SetupOperation of PIP and POP Format Definitions Signal DefinitionsTV Display Formats DVD Definitions57%JTQMBZ TV Disc or Digital Ieee 1394 Device On-Screen InformationAnalog Program Digital ProgramUsing the TV with a PC Connecting a PC See Appendix a for signal compatibilityComputer with an Hdmi Monitor Output Computer with a DVI Monitor Output Computer with a 15-Pin Monitor OutputModels WD-62927 and WD-73927 Adjusting Image Resolution Adjusting Image ResolutionPC Display Formats Page Appendix a Specifications Appendix F Cleaning and ServiceAppendix J Troubleshooting Appendix a Specifications TV SpecificationsInputs Outputs Appendix B NetCommand Specialized Device Keys Deactivating the Front Button Lock Appendix CBypassing the V-Chip Lock Bypassing the V-Chip LockThis page intentionally blank Cable Boxes Appendix D Remote Control Programming CodesProgramming the Remote to Control NetCommand A/V Products ReceiversDVD Players Satellite Receivers/SAT/DTVVCRs DVD position TV positionCable/SAT/DTV position VCR positionNetCommand Compatible Traditional Devices Analog Appendix E Device Control with NetCommandIeee 1394 Devices When an Ieee 1394 Device is Viewed or PlayedAppendix F Cleaning and Service Do not touch the glass parts of the lamp cartridge Appendix G Lamp Cartridge ReplacementWash Your Hands THOROUGHLY, AS this Lamp Contains Mercury See detail Appendix H Diamond Shield Removal and InstallationRaised Lip Channel Install TrimNotched edge Down TV ScreenPry up from the notches at both ends Install the Diamond ShieldStep Hook the top End over Raised lip Step Hook the lower End over Raised lipAppendix I Recording and Viewing Combinations Analog VCR Connected to Audio and Video Record OutputsDigital VCR or A/V Disc Connected to IEEE-1394 Port Appendix J Troubleshooting Symptom RemarksGeneral TV Operation PIP Picture IndicatorsRecording SoundExcessive digital artifacts when viewing an Ieee TV Guide On Screen Trademark and License Information Mitsubishi TV Software 123 Mitsubishi DLP Projection Television Limited Warranty124 This Limited Warranty does not CoverIndex IndexIndex Page Website Mail MDEAservice@mdea.com
Related manuals
Manual 86 pages 7.9 Kb