Mitsubishi Electronics WD-62827 manual Adjusting Image Resolution

Page 94

Adjusting Image Resolution

Adjusting Image Resolution

Figure 4

Your Mitsubishi TV can display resolutions from standard VGA (640 x 480) through XGA (1024 x 768) at 60‑Hz refresh rates. Models WD-62927 and WD-73927 additionally support 1920 x 1080 signals on the 15-pin PC INPUT. See Appendix A in this book for more on compatible screen resolutions. The instructions below are for setting the resolution on most PCs.

1.In the PC’s Start menu, select Settings.

2.Select Control Panel.

3.Select Display.

4.Choose the Settings tab.

5.Change the resolution to the highest resolution with the aspect ratio best suited for the image. See the table on the next page showing possible PC formats. Depending on your PC, adjust the resolution with either:

•the Screen area slider.

•the Screen Resolution slider

You may need to restart the PC for this change to take effect.

Hint: Whenever the TV is powered on, the lamp is in use, even if the TV screen appears dark. As a reminder that the TV is powered on and that time

is being added to the lamp’s elapsed hours, set the computer’s screen saver to a pattern that will display after several minutes of inactivity.

1.

4.

5.

2.3.

Figure 4. PC resolution XGA selection

94Chapter 7. Using the TV with a PC

Image 94

Contents Visit our website at TV InformationStand Requirement TV Guide On Screen Access RequirementsWhile Under Warranty After Warranty TV Model Number Stand Model NumberFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Our Thanks Mitsubishi Digital Electronics America, IncChapter TV Accessories Special Features of Your TV Memory Card Reader Widescreen Picture FormatTV Guide On Screen Interactive Program Guide System Input 3 and Ieee 1394 Input/Output Memory Card Reader and Front-Panel InputsCard Compatibility Front-Panel Indicator Lights Lamp Indicator ResetFront Control Panel Status Indicator Power/Timer IndicatorRemote Control OverviewSleep Timer Battery InstallationCare Input 1 IR Emitter NetCommandTV Back Panel . Component 1-3 InputsMonitorLink/RS-232C Control DVI Analog AudioHdmi 1 DTVLink/IEEEAdditional Information System Reset ButtonDemo Track Connecting Connecting External Devices and NetCommand Setup Audio cablesStandard Cable Box Connecting a Wall Outlet Cable or Cable BoxWall Outlet Cable Can be used with a CableCARDFor antennas with flat twin leads Antenna with a Single LeadAntennas with Separate UHF and VHF Leads For cable or antenna with coaxial leadVCR to an Antenna or Wall Outlet Cable Audio & Video $3CBDLQBOFMConnecting a VCR to a Cable Box Audio & Video VCR to a Cable Box Audio & VideoSatellite Receiver or Other Device with S-Video Receiver Stereo SystemTo connect an analog A/V receiver DVD Player with Component Video See Appendix a for component video signalDVI Device Hdtv Cable Box or Satellite Receiver with Component Video Hdmi DeviceConnecting a MonitorLink Control/RS-232C Device MonitorLink Control/RS-232C DeviceConnecting the IR Emitter NetCommand TJFEEFWJDFTConnection Styles Connecting Compatible Ieee 139 Devices-Pin-Style vs -Pin-Style Connectors Direct Device-To-Device StyleDigital Audio Signals When Connecting Ieee 139 DevicesDigital Video Signals Digital Control SignalHelpful Hints for NetCommand Connections NetCommand Setup and Editing NetCommand Introduction Receiver Cable Box SAT Satellite DVD Player Using the Remote Control with NetCommandNetCommand Pre-Memorized Devices ReceiverNetCommand Setup On-Screen Buttons Remote Control Buttons 3D Graphical Menu SystemNetCommand Information Screen NetCommand Initial SetupWelcome Screen Device Setup Screen Review Screen NetCommand Initial Setup, Setup ReminderSetup Reminder Finish ScreenReceiver Screen Edit NetCommand Adding an A/V ReceiverReceiver Inputs Receiver AVR Input Learn Screen Receiver AVR Learn ScreenName Screen Audio Output to AVR ScreenEdit NetCommand Screen Edit NetCommand Adding DevicesNew Device Screen Device Screen Device Learn ScreenDevice Advanced Learn Screen Connection for Device ScreenIR Code for Device Screen VCR for Recordings ScreenRF Connection for Cable Screen Change Device Screen Edit NetCommand Changing or Deleting DevicesDelete Device Screen Ieee 1394 Devices and NetCommand Control Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyNew 1394 Device Screen Name for 1394 Device Screen Ieee 139 Device Type Screen Adding Ieee 139 Devices AutomaticallyConnection Screen Page NetCommand Functions Audio Section Device Selection MenuPIP Device Selection Menu Video SectionCableCARD Menu Using the Device Menu Button to Display MenusDevice Menu IR Controlled DevicesGuide Button Using the Guide Button to Display ChannelView and MenusGuide and the Recording Setup Screen Guide and the Device Selection MenuTime-Delayed Recording NetCommand-Controlled RecordingsSetting up Recordings Record ListTV Disc and A/V Disc Track List Screen Direct VCR Recording from an Antenna or Cable SourceTV Disc and A/V Disc Search by Time Copy-Protected MaterialUsing the Remote Control with TV Disc or an A/V Disc Using TV Disc and A/V DiscsCopying or Moving TV Disc or A/V Disc Recordings Cancelling a Peer-to-Peer Connection What is a Peer-to-Peer Connection?Setting up a Non-Recording Peer-to- Peer Connection Peer-to-Peer ConnectionsTV Menu Operations Main Menu Memorize Channels Setup MenuLanguage ClockLamp Reminder TimerSoftware Version Edit NetCommand MenuRemote Control Transport Buttons Icon OrderControlling TV Pause Features TV PauseTimeShuttle and TV Disc Recordings TimeShuttleTV Pause with TimeShuttle To Turn Off TimeShuttleRecord Menu Recording SetupTime-Delayed Recording RecordTV Guide On Screen and the Record List Default Digital Record DeviceCancel Scheduled Recordings Analog RecordingsChannel Menu Signal Strength SQV SuperQuickViewAnalog Captions Digital SettingsCaptions Menu BackgroundColor FontsSize Opacity FontChip Lock Menu Setting a Pass CodeSetting V-Chip Options Chip Lock Menu OverviewFront Button Lock V-CHIP ButtonLock by Time Bypassing V‑Chip Lock and Lock by TimeContent Categories Chip Signal InformationChip Ratings Audio/Video Menu Analog-Only Audio Settings Audio SettingsAnalog and Digital Audio Settings Digital-Only Audio SettingsVideo Settings Video SettingsPC Video Settings Page MediaCommand and Memory Card Playback CableCARDCableCARD Using a CableCARDCableCARD Technology MediaCommand and Memory Card Playback Memory Card SlotsFor Jpeg Picture Slide Show Setup Media Command and Memory Card PlaybackMedia Setup Menu For MP3 or WMA Audio Playlist SetupOperation of PIP and POP DVD Definitions Signal DefinitionsTV Display Formats Format Definitions57%JTQMBZ Digital Program On-Screen InformationAnalog Program TV Disc or Digital Ieee 1394 DeviceUsing the TV with a PC See Appendix a for signal compatibility Connecting a PCComputer with an Hdmi Monitor Output Computer with a 15-Pin Monitor Output Computer with a DVI Monitor OutputModels WD-62927 and WD-73927 Adjusting Image Resolution Adjusting Image ResolutionPC Display Formats Page Appendix F Cleaning and Service Appendix a SpecificationsAppendix J Troubleshooting TV Specifications Appendix a SpecificationsInputs Outputs Appendix B NetCommand Specialized Device Keys Bypassing the V-Chip Lock Appendix CBypassing the V-Chip Lock Deactivating the Front Button LockThis page intentionally blank Receivers Appendix D Remote Control Programming CodesProgramming the Remote to Control NetCommand A/V Products Cable BoxesSatellite Receivers/SAT/DTV DVD PlayersVCRs VCR position TV positionCable/SAT/DTV position DVD positionAppendix E Device Control with NetCommand NetCommand Compatible Traditional Devices AnalogWhen an Ieee 1394 Device is Viewed or Played Ieee 1394 DevicesAppendix F Cleaning and Service Appendix G Lamp Cartridge Replacement Do not touch the glass parts of the lamp cartridgeWash Your Hands THOROUGHLY, AS this Lamp Contains Mercury Appendix H Diamond Shield Removal and Installation See detailTV Screen Install TrimNotched edge Down Raised Lip ChannelStep Hook the lower End over Raised lip Install the Diamond ShieldStep Hook the top End over Raised lip Pry up from the notches at both endsAnalog VCR Connected to Audio and Video Record Outputs Appendix I Recording and Viewing CombinationsDigital VCR or A/V Disc Connected to IEEE-1394 Port Symptom Remarks Appendix J TroubleshootingGeneral TV Operation PIP Indicators PictureSound RecordingExcessive digital artifacts when viewing an Ieee TV Guide On Screen Trademark and License Information Mitsubishi TV Software Mitsubishi DLP Projection Television Limited Warranty 123This Limited Warranty does not Cover 124Index IndexIndex Page MDEAservice@mdea.com Website Mail

Related manuals

Manual 86 pages 7.9 Kb