Allied Telesis management software layer 2+ fast ethernet switches manual

AT-S62 Command Line User’s Guide

SET PORTACCESSPORTAUTH PORT ROLE=SUPPLICANT

Syntax

set portaccessportauth port=port typerole=supplicantnone [authperiod=value] [heldperiod=value] [maxstart=value] [startperiod=value] [usernamename=name] [password=password]

Note

The PORTACCESS and PORTAUTH keywords are equivalent.

Parameters
port	Specifies the port that you want to set to the
	Supplicant role or whose Supplicant settings you want
	to adjust. You can specify more than one port at a
	time.
type	Specifies the role of the port. The parameters are
role	equivalent. The role can be one of the following:
	supplicant	Specifies the Supplicant role.
	none	Disables port-based access
		control on the port.
authperiod	Specifies the period of time in seconds that the
	supplicant will wait for a reply from the authenticator
	after sending an EAP-Response frame. The range is 1
	to 60 seconds. The default is 30 seconds.
heldperiod	Specifies the amount of time in seconds the
	supplicant is to refrain from retrying to re-contact
	the authenticator in the event the end user
	provides an invalid username and/or password.
	Once the time period has expired, the supplicant
	can attempt to log on again. The range is 0 to
	65,535. The default value is 60.
maxstart	Specifies the maximum number of times the
	supplicant will send EAPOL-Start frames before
	assuming that there is no authenticator present.
	The range is 1 to 10. The default is 3.

489