Allied Telesis management software layer 2+ fast ethernet switches manual Increase, Traffic class

Chapter 20: Quality of Service (QoS) Commands
	the traffic. However, no unused tokens will
	accumulate in the bucket. If the traffic
	increases, the excess traffic will be discarded
	since no tokens are available for handling the
	increase.
	If the traffic is below the maximum
	bandwidth, unused tokens will accumulate in
	the bucket since the actual bandwidth falls
	below the specified maximum. The unused
	tokens will be available for handling excess
	traffic should the traffic exceed the maximum
	bandwidth. Should an increase in traffic
	continue to the point where all the unused
	tokens are used up, packets will be discarded.
	Unused tokens accumulate in the bucket
	until the bucket reaches maximum capacity,
	set by this parameter. Once the maximum
	capacity of the bucket is reached, no extra
	tokens are added. The range is 4 to 512 Kbps.
	This parameter must be used with the
	MAXBANDWIDTH parameter. Specifying a
	token bucket size without also specifying a
	maximum bandwidth serves no function.
priority	Specifies the priority value in the IEEE 802.1p
	tag control field that traffic belonging to this
	traffic class is assigned. Priority values range
	from 0 to 7 with 0 being the lowest priority
	and 7 being the highest priority. Incoming
	frames are mapped into one of four Class of
	Service (CoS) queues based on the priority
	value.
	If you want the packets to retain the new
	value when they exit the switch, use the
	REMARKPRIORITY parameter.
	A new priority can be set at both the flow group
	and traffic class levels. If it is set in both places,
	the value in the flow group overrides the value in
	the traffic class.
remarkpriority	Replaces the user priority value in the packets
	with the new value specified with the PRIORITY
	parameter. This parameter is ignored if the
	PRIORITY parameter is omitted or set to NONE.
	Options are:

322