Allied Telesis management software layer 2+ fast ethernet switches manual Preface

Preface

This guide describes how to configure an AT-8500 Series switch using the AT-S62 command line interface. The commands are grouped by topic into the following chapters:

❑Chapter 1: Starting a Command Line Management Session on page 16

❑Chapter 2: Basic Command Line Commands on page 20

❑Chapter 3: Enhanced Stacking Commands on page 30

❑Chapter 4: Basic Switch Commands on page 36

❑Chapter 5: Simple Network Time Protocol (SNTP) Commands on page 70

❑Chapter 6: SNMPv1 and SNMPv2 Community Strings and Trap Commands on page 80

❑Chapter 7: SNMPv3 Commands on page 99

❑Chapter 8: Port Parameter Commands on page 157

❑Chapter 9: MAC Address Table Commands on page 177

❑Chapter 10: Port Trunking Commands on page 186

❑Chapter 11: Networking Stack Commands on page 194

❑Chapter 12: LACP Commands on page 204

❑Chapter 13: Port Mirroring Commands on page 219

❑Chapter 14: Statistics Commands on page 223

❑Chapter 15: File System Commands on page 227

12