Allied Telesis management software layer 2+ fast ethernet switches Trap, and disables the port

		AT-S62 Command Line User’s Guide
intrusionaction	Specifies the action taken by the port in the event
	port security is violated. This parameter applies only
	to the Limited security mode. Intrusion actions are:
	discard	Discards invalid frames. This is the
		default setting.
	trap	Discards invalid frames and sends a
		SNMP trap.
	disable	Discards invalid frames, sends an SNMP
		trap, and disables the port.
learn	Specifies the maximum number of dynamic MAC
	addresses a port on the switch can learn. This
	parameter applies only to ports set to the Limited
	security mode. The range is 1 to 255 addresses. The
	default is 255.
participate	Enables or disables the intrusion action on the port.
	This option only applies to the Limited security mode
	and only when a port’s intrusion action is set to trap or
	disable. This option does not apply when intrusion
	action is set to discard. Options are:
	yes, on, true	Enables the trap or disable intrusion
		action. These values are equivalent.
	no, off, false	Disables the trap or disable intrusion
		action. The port still discards invalid

ingress frames. This is the default. These values are equivalent.

Description

This command sets and configures a port’s security mode. Only one mode can be active on a port at a time.

Note

Refer to the AT-S62 Management Software Menus Interface User’s Guide for explanations of the security levels and intrusion actions.

To view a port’s current security mode, use the command SHOW SWITCH PORT SECURITYMODE on page 478.

The management software displays a confirmation prompt whenever you perform this command. Responding with Y for yes completes your command, while N for no cancels the command.

475