Allied Telesis management software layer 2+ fast ethernet switches manual ADD Snmp Community

AT-S62 Command Line User’s Guide

ADD SNMP COMMUNITY

Syntax

add snmp community=”community” [traphost=ipaddress] [manager=ipaddress]

Parameters
community	Specifies an existing SNMP community string on the
	switch. This parameter is case sensitive. The name
	must be enclosed in double quotes if it contains a
	space or special character, such as an exclamation
	point. Otherwise, the quotes are optional.
traphost	Specifies the IP address of a trap receiver.
manager	Specifies the IP address of a management
	workstation to have SNMP access to the switch
	using the community string.
Description

This command adds the IP address of a trap receiver or a management station to an existing community string.

The TRAPHOST parameter specifies a trap receiver for the SNMP community string. This is the IP address of a device to which traps generated by the switch are sent. A community string can have up to eight IP addresses of trap receivers, but only one can be added at a time with this command.

The MANAGER parameter specifies a management station to be allowed SNMP management access to the switch using the community string. This parameter applies only to community strings with a closed status. A community string can have up to eight IP addresses of management stations, but only one can be added at a time with this command.

To create a new community string, refer to CREATE SNMP COMMUNITY on page 83. To view the current community strings, refer to SHOW SNMP on page 97.

Examples

The following command permits access by a management station with the IP address 149.212.11.22 to the switch through the “private” community string:

add snmp community=private manager=149.212.11.22

81