Allied Telesis management software layer 2+ fast ethernet switches manual Show Switch Port

Chapter 8: Port Parameter Commands

SHOW SWITCH PORT

Syntax

show switch port[=port]

Parameter
port	Specifies the port whose parameter settings you
	want to view. You can specify more than one port at
	a time. You can specify the ports individually (for
	example, 5,7,22), as a range (for example, 18-23), or
	both (for example, 1,5,14-22). All ports are displayed
	if you omit the port number.
Description

This command displays a port’s operating parameters, such as speed and duplex mode. Refer to the AT-S62 Management Software Menus Interface User’s Guide for details on port parameters.

A GBIC or SFP module in Port 49 or 50 of an AT-8550GB or AT-8550SP switch must have a valid connection to an end node in order for you to view its parameter settings. Otherwise, specifying Ports 49 and 50 display the parameter settings of the twisted pair ports 49R and 50R.

Examples

The following command displays the operating settings for all ports:

show switch port

The following command displays the operating settings for port 14:

show switch port=14

176