Allied Telesis management software layer 2+ fast ethernet switches manual ADD LOG Output

AT-S62 Command Line User’s Guide

ADD LOG OUTPUT

Syntax

add log output=id_number module=allmodule severity=allseverity

Parameters
output	Specifies the ID number of a syslog server definition.
module	Specifies the AT-S62 modules whose events are to
	be sent to the syslog server. The available options
	are:
	all	Sends events from all modules.
	module	Sends events from selected module(s). To
		specify more than one module, separate
		them with commas, for example,
		MAC,PACCESS. For a list of the modules,
		see Table 4 on page 279.
severity	Specifies the severity of events to send to the syslog
	server. The options are:
	all	Sends events of all severity levels.
	severity	Sends events of a selected severity.
		Choices are I for Informational, E for Error,
		W for Warning, and D for Debug. You can

specify more than one severity (for example, E,W). For a definition of the severity levels, see Table 5, “Event Log Severity Levels” on page 281.

Description

This command configures a syslog server definition.

There are two steps to creating a syslog server definition from the command line interface. The first is to create the definition using CREATE LOG OUTPUT on page 262. With that command you assign the definition an ID number, the IP address of the syslog server, and other information.

259