AT-S62 Command Line User’s Guide

SET STP PORT

Syntax

set stp port=port [pathcostportcost=autoportcost] [portpriority=portpriority]

Parameters

 

port

Specifies the port you want to configure. You can

 

configure more than one port at a time. You can

 

specify the ports individually (for example, 5, 7, 22), as

 

a range (for example, 18-23), or both (for example, 1, 5,

 

14-22).

pathcost

Specifies the port’s cost. The parameters are

portcost

equivalent. The spanning tree algorithm uses the cost

 

parameter to decide which port provides the lowest

 

cost to the root bridge for that LAN. This parameter

 

can take the range of 1 to 65,535, or AUTO. The default

 

setting is AUTO, for Automatic Update, which

 

automatically sets port cost according to the speed of

 

the port. Table 2 lists the STP port costs with Auto-

 

Detect.

 

Table 2 STP Auto-Detect Port Costs

Port Speed

Port Cost

10 Mbps

100

100 Mbps

10

1000 Mbps

4

Table 3 lists the STP port costs with Auto-Detect when a port is part of a port trunk.

Table 3 STP Auto-Detect Port Trunk Costs

Port Speed

Port Cost

10 Mbps

4

100 Mbps

4

1000 Mbps

1

387

Page 387
Image 387
Allied Telesis management software layer 2+ fast ethernet switches manual SET STP Port