Mitsubishi Electronics WD-62827 Install the Diamond Shield, Step Hook the top End over Raised lip

Appendix H: Diamond Shield Removal and Installation, continued

7.Refer to figure 8 and install the two side-trim pieces as follows:

(1)Hook the lower end of the trim over the raised lip running down the side of the TV screen.

(2)While keeping the end of the trim hooked on the raised lip, slide the trim down until it meets the lower trim piece.

(3)Hold the bottom end of the trim in place and hook the top end on the raised lip that runs along the top edge of the screen.

(4)Push the top end of the trim up against the edge of the screen. Press the full length of the trim onto the raised lip.

(5)Press the outer edge of the trim so that the entire length snaps into place.

8.Refer to figure 9 and install the upper trim piece as follows:

(1)Center the upper trim piece in front of the TV and hook both ends of the trim on the raised lip running along the top of the TV screen.

The trim piece may bow out slightly.

(2)Push the full length of the trim in place over the raised lip.

9.Set the top plate in position and secure it with the original screws.

	Step (3)
	Hook the top
	end over the
	raised lip.
		Step (4)
Figure 8. Hook the ends
of the trim piece over the
raised lip at the top and
side of the TV screen.	Step (1)
	Hook the lower
	end over the
	raised lip.

Figure 9. Center the upper trim piece and press it onto the raised lip that runs along the top of the TV screen

Install the Diamond Shield

1.Using a Phillips screwdriver, remove the screws that secure the top plate and lift off the plate. Keep the plate and screws for reuse. See figure 1.

2.Pull off the four trim pieces surrounding the TV screen. Pry the lower trim piece off from the notches at both ends. See figure 10.

3.Support the Diamond Shield at both ends and set it into the channel located below the TV screen.

4.Press the shield clips into the channels running alongside the screen.

5.Set the top plate in position and secure it with the original screws.

Pry up from the notches at both ends

Figure 10. Pry off the lower trim piece last.

Appendices 113