Mitsubishi Electronics WD-62827 manual Connecting a PC, Computer with an Hdmi Monitor Output

Connecting a PC

Overview

1.Connect the Computer to the TV

See the connection diagrams in this chapter to find the method best suited to your needs.

2.Perform NetCommand Setup for the PC

•For first-time NetCommand setup:

Start NetCommand setup as described in chapter 3 and check mark the PC check box in the Device Setup screen.

•If NetCommand has already been set up: Press TV MENU and select the NetCommand icon. In the Edit NetCommand screen, select Add and follow the on-screen prompts to add the PC. See chapter 3 for more information.

3.Select the PC in the Device Selection menu

1Press DEVICE to open the Device Selection menu.

2.Move the highlight to the PC icon.

3.Press DEVICE again to close the menu.

4.Change the resolution of the PC image

Maximize the resolution while maintaining a suitable aspect ratio for the image. See the explanation later in this chapter.

5.Perform TV video adjustments

Press VIDEO repeatedly until you see the PC video settings displayed on screen. Your choices are:

Auto Position. Press ENTER to automatically center the position of the PC video.

HorizPosition (Horizontal Position). Manually adjust the horizontal position of the PC. This selection overrides the Auto Position selection.

VertPosition (Vertical Position). Manually adjust the vertical position of the PC. This selection overrides the Auto Position selection.

Fine Detail. Manually adjust the picture quality of the PC. This selection overrides the Auto Position selection.

6.Change the TV picture format

Press FORMAT to cycle through the available picture formats. See the chart later in this chapter showing how various PC resolutions are displayed on the TV.

Computer with an HDMI Monitor Output

Figure 1

An HDMI-to-HDMI cable is required. This is not included with the TV. It may be available at your local electronics retailer

1.Connect an HDMI cable from HDMI 2 on the TV back panel to the PC’s HDMI output. Both video and audio are provided through this single cable.

2.Models WD-62927 and WD-73927 only:

a.Perform the NetCommand PC setup described in step 2 under “Overview” on this page.

b.Select the NetCommand Change option as follows:

(1)Press TV MENU.

(2)Highlight the NetCommand icon and press

ENTER.

(3)Highlight Change and press ENTER.

3.In the Connection for PC screen, change TV Input from PC to HDMI-2.

4.Advance to the finish screen to complete the change.

					1$ '03 )%.* 
					0/-:  )[
			)%.* 		7(" 87("
					47(" 847("
					9("  9 
*3 &.*55&3
/FU $PNNBOE¸
					.0/*503-*/,™
					$0/530-34$
$"#-&
'6)'
64& 8*5)
$BCMF$"3%™		%*(*5"-
		"6%*0	$BCMF$"3%™ 64& 8*5) "/5  $"3% 501
"/5   "69	"/5   ."*/	065165
					*&&& 
					*/165
					065165

1$
XJUI
)%.*

0VUQVU

Figure 1. Connecting a Computer with an HDMI Monitor Output

CAUTION: To ensure continued FCC compliance, the user must use a shielded video interface or HDMI cable

with bonded ferrite cores at both ends when using the PC input.

IMPORTANT

•After connecting the PC, activate the PC option in NetCommand. Do this either during initial NetCommand setup (in the Device Setup screen), or at any time afterwards with the NetCommand Add function. See chapter 3.

•See Appendix A for signal compatibility.

92Chapter 7. Using the TV with a PC