One for All URC-9964B00 manual Programming Device Control, Setting the Vibration Switch

OFA Kameleon wRF UG rev 3.fm Page 15 Monday, September 13, 2004 11:18 AM

USER’S GUIDE

SETTING THE VIBRATION SWITCH

The OFA Kameleon 8-Device Remote with RF is set at the factory to turn the display on when you pick it up, before you even press a button (the vibration switch is on). To turn vibration off, perform the following steps.

1.Press and hold SETUP until the two bottom IR segments flash twice. The

Program Keys appear.

NOTE: Turning off the vibration switch can significantly extend battery life.

NOTE: If the display turns off because of inactivity, you must start the programming sequence again by repeating this step.

2.Press OTHER once.The Other programming screen appears:

3.Using the Number Keys, enter 9 8 5.

The bottom two IR segments flash four times, to indicate vibration switch has been turned off.

4. Press HOME twice to exit programming and return to the last-selected device menu screen.

To turn vibration switch back on, repeat steps 1 to 4 above. Note that the bottom two IR segments flash twice (in step 3), to indicate that the vibration switch is back on.

PROGRAMMING DEVICE CONTROL

The OFA Kameleon 8-Device Remote with RF is preset at the factory to operate the following devices:

•	Motorola Cable Box (using	•	RCA TV,VCR, and Satellite
	the AUX key)		Receiver
•	Philips Tivo PVR (DVR)	•	Toshiba DVD Player

•Pioneer CD Player and Audio Receiver

Programming Device Control 15