One for All URC-9964B00 manual Restoring Factory Default Settings

OFA Kameleon wRF UG rev 3.fm Page 40 Monday, September 13, 2004 11:18 AM

KAMELEON 8-DEVICE REMOTE WITH RF

3.Press OTHER once.The Other programming screen appears:

4.Using the Number Keys, enter 9 9 6.

The two bottom IR segments flash twice and display the Favorite Channel programming screen.

NOTE: If the two bottom IR segments display one long flash, an error has occurred. Try repeating this step.

5.Using the Number Keys, enter a favorite

channel number (e.g., 0 1 2). Then press SETUP once.The two bottom IR segments flash three times confirming your entry.

NOTE: If the original remote control required pressing an Enter key to change the channel, also press the ENTER key after the channel number (e.g., 0 1 2 ENTER).

6.If desired, repeat step 5 for each channel to be stored, up to a total of 10 channels.

NOTE: After storing 10 channels, the remote control exits the Favorite Channel programming screen and again displays the Program Keys.

7.To exit programming with fewer than 10 favorite channels stored, press and hold SETUP until the two bottom IR segments flash twice and then press HOME once.The display returns to the last-selected device menu screen.

RESTORING FACTORY DEFAULT SETTINGS

The OFA Kameleon 8-Device Remote with RF includes an Setup Code Reset program.You can use it to restore all your programmed codes to factory settings and delete all custom programming.

IMPORTANT: Executing this program erases all code settings and all custom settings for Home Theater, Macros, Learned Keys, Reassigned Device Keys, Keymoved Keys, Favorite Channels, and all device settings.

40 Restoring Factory Default Settings