3M 78-8135-4385-3-A manual

Page 10

10.2 Snip the aramid yarn to 5-6 mm (approx. 3/16").

10.3 Flare aramid yarn evenly around buffer.

10.4Using the 3M™ Stripping Tool 6365-ST, remove the buffer in small increments until 21–22 mm (approx. 7/8") of buffer is left.

10.5Using a lint-free cloth moistened with isopropyl alcohol, clean the bare ﬁber to remove any oils or acrylate coating debris.

10.6 Check the ﬁnal strip lengths and adjust if necessary

10	78-8135-4385-3-A

Image 10

Contents LC Hot Melt Fiber Optic Connectors Contents Safety and Helpful Hints Hot Melt Oven Safety Information3M LC Expansion 6650-LC Kit Contents 3M LC Connectors C DSetup C D E78-8135-4385-3-A 1.6 2.0 mm Jacketed Cable Connector Preparation 900 micron Cable Connector Preparation3.0 mm Jacketed Cable Connector Preparation Strip Guide Stripping Procedure for 900 micron Fiber Stripping Procedure for 1.6 2.0 mm Jacketed Fiber78-8135-4385-3-A Stripping Procedure for 3 mm Jacketed Fiber Connector Mounting CAUTION Boot Placement for 900 micron Fiber Crimping and Boot Placement for 1.6 2.0 mm Jacketed Fiber78-8135-4385-3-A Crimping and Boot Placement for 3 mm Jacketed Fiber Scribing Multimode Polish 78-8135-4385-3-A 78-8135-4385-3-A Singlemode Polish to -40db 78-8135-4385-3-A Singlemode Polish to -55db Installing Duplex Yokes Finishing78-8135-4385-3-A 22.0 3M Expansion Kit 6650-LC and Replacement Part Numbers 80-6113-1355-478-8135-4385-3-A Communication Markets Division 3M Telecommunications