3M 78-8135-4385-3-A manual

Page 20

17.11Polish 10 figure-eight strokes or until bead of adhesive is no longer visible.

Note: Do not hold polishing jig assembly by the weight when polishing. Hold only by the textured polishing adapter.

Note: Because bead is 3 to 4 times smaller than classic hot melt connectors you will not feel the bead of adhesive being removed as you polish.

IMPORTANT: Make sure that polishing jig stays flat on lapping film at all times

17.12After bead of adhesive is no longer visible, polish an additional 5 strokes.

17.13Remove the connector from the polishing jig assembly and clean the connector endface with a lint-free cloth moistened with isopropyl alcohol.

17.14Inspect the connector endface with the 200X Westover™ Scientific fiber view scope. Use the thumb toggle switch to activate the light onto the fiber end face. There are two light settings—coaxial and oblique angle lighting.

20

78-8135-4385-3-A

Page 19 Page 21
Image 20
Page 19 Page 21
Contents LC Hot Melt Fiber Optic Connectors Contents Safety and Helpful Hints Hot Melt Oven Safety Information3M LC Expansion 6650-LC Kit Contents 3M LC Connectors C DSetup C D E78-8135-4385-3-A 3.0 mm Jacketed Cable Connector Preparation 900 micron Cable Connector Preparation1.6 2.0 mm Jacketed Cable Connector Preparation Strip Guide Stripping Procedure for 900 micron Fiber Stripping Procedure for 1.6 2.0 mm Jacketed Fiber78-8135-4385-3-A Stripping Procedure for 3 mm Jacketed Fiber Connector Mounting CAUTION Boot Placement for 900 micron Fiber Crimping and Boot Placement for 1.6 2.0 mm Jacketed Fiber78-8135-4385-3-A Crimping and Boot Placement for 3 mm Jacketed Fiber Scribing Multimode Polish 78-8135-4385-3-A 78-8135-4385-3-A Singlemode Polish to -40db 78-8135-4385-3-A Singlemode Polish to -55db Installing Duplex Yokes Finishing78-8135-4385-3-A 22.0 3M Expansion Kit 6650-LC and Replacement Part Numbers 80-6113-1355-478-8135-4385-3-A Communication Markets Division 3M Telecommunications
Top Page Image Contents