3M 78-8135-4385-3-A manual

Page 7

4.4Insert the connector into the hot melt connector holder.

4.5Place the load adapter, with slot aligned with handle, into an available port in the oven.

IMPORTANT: Do not place connector in a hot load adapter. This may cause adhesive to ﬂow to the outside of the ferrule. Load adapter should be at room temperature when connector is inserted.

4.6The 3M™ LC Hot Melt Connector should be in the oven for at least 75 seconds. The connector should not be in the oven longer than 5 minutes.

4.7Place the heat shrink ﬁxture in an available port in the oven.

Note: This step is only necessary for use with the 1.6–2.0 mm jacketed LC hot melt connector.

78-8135-4385-3-A

7

Image 7

Contents LC Hot Melt Fiber Optic Connectors Contents Hot Melt Oven Safety Information Safety and Helpful Hints3M LC Expansion 6650-LC Kit Contents C D 3M LC ConnectorsC D E Setup78-8135-4385-3-A 1.6 2.0 mm Jacketed Cable Connector Preparation 900 micron Cable Connector Preparation3.0 mm Jacketed Cable Connector Preparation Stripping Procedure for 1.6 2.0 mm Jacketed Fiber Strip Guide Stripping Procedure for 900 micron Fiber78-8135-4385-3-A Stripping Procedure for 3 mm Jacketed Fiber Connector Mounting CAUTION Crimping and Boot Placement for 1.6 2.0 mm Jacketed Fiber Boot Placement for 900 micron Fiber78-8135-4385-3-A Crimping and Boot Placement for 3 mm Jacketed Fiber Scribing Multimode Polish 78-8135-4385-3-A 78-8135-4385-3-A Singlemode Polish to -40db 78-8135-4385-3-A Singlemode Polish to -55db Finishing Installing Duplex Yokes78-8135-4385-3-A 80-6113-1355-4 22.0 3M Expansion Kit 6650-LC and Replacement Part Numbers78-8135-4385-3-A Communication Markets Division 3M Telecommunications