Hookups (cont’d) 11
Connecting to a TV and a Cable Box or Satellite Receiver
Cable TV Signal
OUTIN
Cable Box
To front of Cable Box
IN - EXT 2 | IN - EXT 1 | OUT 2 | OUT 1 480p/480i |
VIDEO | AUDIO COMPONENT | VIDEO | AUDIO COMPONENT |
(CVBS) | VIDEO | (CVBS) | VIDEO |
ANTENNA |
| Y |
|
| Y |
|
|
|
| ||
|
|
|
| ||
(Y/C) | L | PB | (Y/C) | L | PB |
|
|
|
| ||
TV | AUDIO |
|
| AUDIO |
|
R | PR |
| R | PR | |
|
|
|
|
MAINS
DIGITAL AUDIO OUT | |
COAX OUT | OPTICAL OUT |
Back of TV
(example only)
DIGITAL AUDIO OUT | DIGITAL AUDIO OUT | |
COAX OUT |
| OPTICAL OUT |
This example shows a Cable Box, but the steps are the same for a Satellite Receiver. Do not use the
1 Connect your Cable TV signal to the ANTENNA IN jack on your Cable Box.
2 If your Cable Box has an ANTENNA OUT or TO TV jack, connect an RF coaxial cable to it and to the Recorder’s ANTENNA jack.
If your Cable Box has red, white, and yellow AUDIO and VIDEO OUT jacks, use the supplied audio and video cables to connect those jacks to the Recorder’s IN EXT 2 VIDEO (CVBS) and AUDIO L/R jacks instead.
3 Connect an RF coaxial cable to the Recorder’s TV jack and to the ANTENNA IN or RF IN jack on your TV. Your TV’s Antenna In jack may be labelled RF In or 75 ohm. Check your TV manual for details.
4 Connect the supplied power cord to the MAINS ~ (AC Power) jack
on the rear of the Recorder. Connect the power cords of the Recorder, Cable Box/Satellite Receiver, and TV to a power outlet.
5 If you have a Cable Box, remove the Demo Pin from the Recorder’s G- LINK jack. (This should have been in place when you bought the Recorder.) Connect the supplied
6 Press STANDBY/ON y to turn on the Recorder. Set the Recorder to channel 3 or 4 (your Cable Box output channel) if you used an RF coaxi- al cable at step 2. Or, set the Recorder to EXT 2 if you connected the Cable Box to those jacks at step 2.
7 “IS TV ON? CH03” will appear on the Recorder’s display panel the first time you turn it on. Turn on the TV and the Cable Box. Set the TV to chan- nel 3 to receive the picture from the Recorder.
You should see the blue Philips DVD background picture or the Initial Setup screen. Initial Setup appears the first time you turn on the Recorder. Go to pages
Helpful Hints
•To watch TV, put the Recorder in Monitor mode and on channel 3 or 4. (Press MONITOR on the Recorder’s remote.) Change TV channels at your Cable Box.
•The Recorder’s display may show “IS TV ON? C04” instead. If so, put the TV on channel 4.
•If you need to use TV channel 4 but “IS TV ON? C03” appears on the display, press and hold the Number 4 button on the Recorder’s remote. After several seconds, the display will change to “IS TV ON? C04.” Set your TV to channel 4.
Likewise, if the display shows “IS TV ON? C04” and you need TV channel 3, press and hold Number 3. Use this procedure while the Recorder is on and “IS TV ON?...” shows on the display.
•You can use the connections between the Recorder and a TV/Stereo shown on pages 12- 16 instead. You will choose a dif- ferent Video In channel at the TV.