Philips DVDR80/99 owner manual Safety Information

Page 4

4 Safety Information

Safety Precautions

Warning: To prevent fire or shock hazard, do not expose this equipment to rain or moisture.

Federal Communications Commission (FCC) Warning: Any unauthorized changes or modifications to this equipment void the user’s authority to operate it.

Laser Safety

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10. CAUTION:Visible and invisible laser radiation when open and interlock defeated. Do not stare into the beam.The beam is located inside, near the deck mechanism.

Special Information for Canadian Users

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.

CET APPAREIL NUMÉRIQUE N'ÉMET PAS DE BRUITS RADIOÉLECTRIQUES DÉPASSANT LES LIMITES APPLICA- BLES DANS LA RÈGLEMENT SUR LE BROUILLAGE RADIOÉLECTRIQUES ÉDICTÉ PAR LE MINISTÈRE DES COMMUNICATIONS DU CANADA.

Radio/TV Interference

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a resi- dential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inter- ference to radio or television reception, which can be determined by turning the equipment off and on, try to cor- rect the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and the receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

WARNING:

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT:

This product was FCC verified under test conditions that included use of shielded cables and connectors between system components. Use shielded cables to reduce the possibility of causing interference to radios, televisions, and other electronic devices. If you have any problems, contact your supplier.

Copyright Protection

Unauthorized copying, broadcasting, public performance, and lending of Discs are prohibited.This product incorpo- rates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectu- al property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Note to Cable TV Installer

This reminder is provided to call the Cable TV system installer’s attention to Section 820-40 of the National Electrical Code (NEC), which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Declaration of Conformity

Model Number:

DVDR80

Trade Name:

Philips

Responsible Party:

Philips Consumer Electronics

 

P.O. Box 14810, Knoxville,TN 37914-1810

 

(865) 521-4316

Page 3 Page 5
Image 4
Page 3 Page 5
Contents DVDR80 Dear Philips product owner Remember, to get the most from your Philips prodCard within 10 days. So please mail It to us right now For Customer UseContents Safety Information Safety Information cont’d Example of Antenna Grounding per National Electrical CodeIntroduction Playable Discs Discs for Recording and PlayingDiscs Unsuitable for Recording or Playing Discs for Playing OnlyGeneral Information Hookups Determining the best possible connectionBefore you begin RememberConnecting to a TV Only TV has only an Antenna In jack Hookups cont’dConnecting to a TV and a Cable Box or Satellite Receiver Connecting to a TV Only TV has Component Video In Jacks Connecting to a TV Only TV has an S-Video In Jack Connecting to a TV Only TV has a yellow Cvbs Video In jack Connecting to a TV A Stereo with red/white Audio In jacks Stereo DV S-VIDEO Video Audio Left Right Initial Setup Instructions continue on the nextInitial Setup cont’d Helpful HintGuide Plus+ System Setup Press OK to continuePress Standby y to turn off the Recorder later. Leave the Cable Box turned onQuick Recording Press Monitor to see TV channels through the RecorderTo select an item, then press OK. Continue until you set up Quick Disc PlayPress OPEN/CLOSE a again to close the tray Play may start automatically. If notChapter/Track Selection Title/Disc menusPress Disc Menu during Disc play Remote Control Play Mode Button TV Volume +/- ButtonsDisc Manager Button Standby y ButtonFront Panel Rear Panel Menu Bars 98 symbols in the Menu Bar mean more items are availableMenu Bar On-screen Symbols, Status Box On-screen SymbolsStatus Box Disc status iconsInformation Boxes Timer Information boxTuner Information box Title Settings Menu Index Picture ScreenTitles Disc BarClock Press System MENU. Press to selectPress 9CH- repeatedly to select Press 9CH- repeatedly to select Time/Date, then pressChannel Programming One-Touch Recording To erase a recording, see Erase this title details onTitle or erase the chosen Title from the Disc Press OK to start Disc play at the Title you selectedErase this title Press to return to the Index Picture Screen if necessaryAppend recording Record One Channel/Watch AnotherRecord Settings Mode Picture quality Recording time per DiscChapter Markers Recordings and the maximum recording time for a DiscEditing Disc Information Screen This option is not always available EditingPress FSS $ to remove the menu if necessary Finalize Disc Disc Manager Add current discRemove disc Press Play to close the disc tray and remove the DiscFind title Disc Manager cont’dBrowse discs SETUPReview Guide Plus+ System cont’d Change Channel DisplayReview Options Press GUIDE/TVListings SortTimer Recordings Timer Recording TipsPress Timer X to access the Record screen in the Guide Plus+ SystemSchedule Messages and PromotionsAudio Language Audio Language, SubtitlesSubtitles Zoom, Camera Angle ZoomCamera Angle During DVD play, press the Green Angle Button to SelectSound, Still Picture SoundStill Picture Press System Menu to remove the Menu BarSearching Slow MotionPause k on the remote to pause the picture Time Search, Scan Time SearchScan Press the Number buttons to enter the time at which youRepeat Repeat, Repeat A-BRepeat A-B Access Control Change CodeTwice.This will set your code for the first time Press System Menu to remove the menuChild Lock Locking or Unlocking Specific DiscsAccess Control cont’d Parental LevelChange Country Enter the four-digit code to play the DiscSee the Status boxes. Choose Off if you do not want to see Status boxes. SeePicture Settings Analog Output, Digital Output Analog OutputDigital Output Press 9CH- repeatedly to select G, then pressLanguage Settings SAPNight Mode Remote Control UsedAuto Resume Auto Resume, Playback ControlPlayback Control Glossary Helpful Hints Helpful Hints contd Diagnostic Test Diagnostic Test, SpecificationsSpecifications Renewed Information Index Component video24-25 Video cvbs
Top Page Image Contents