3Use more of your TV
Pause TV
What you can do
While you watch a digital channel, you can pause a programme to answer a phone call or to have a break. The broadcast is stored on a USB hard drive that is connected to the TV. You can resume playback of the programme at any time.
Note:
∙You can pause a programme for a maximum of 90 minutes.
What you need
∙Tune your TV to receive digital channels. See Set up your TV > Channel settings > Automatic install (Page 35).
∙Connect a USB 2.0 compatible hard drive with a minimum capacity of 32 GB and a minimum transfer speed of 30 MB per second.
Install USB hard drive
To pause TV, you must connect a USB hard drive to the TV and format it.
If the TV does not recognise the USB hard drive, use a PC to format it to NTFS file system, then try again.
Caution:
∙TP Vision is not responsible if the USB hard drive is not supported, nor is it responsible for damage to or loss of data in the device.
∙Formatting removes all data from the connected USB hard drive.
∙The USB hard drive is formatted exclusively for this TV. Keep it permanently connected to the TV. You cannot access the USB hard drive contents from another TV or PC.
∙ Do not overload the USB port. If you |
|
connect a USB hard drive device that | English |
make sure that it is connected to its | |
consumes more than 500mA power, |
|
own external power supply. |
|
1.Make sure that the TV and the USB hard drive are switched off.
2.Make sure that there are no other USB devices connected to the TV.
3.Connect the USB hard drive directly to the TV, or if you intend to connect other USB devices in future, connect the USB hard drive through a USB hub.
Note: While you are formatting the USB hard drive, do not connect other USB devices to the TV.
4.Switch on the TV and the USB hard drive, if it has an external power source.
5.Switch to a digital TV channel.
6. Press to start formatting.
7.Follow the onscreen instructions to complete the formatting process. Warning: The formatting process may take some time. Do not switch off the TV or disconnect the USB hard drive until this process is complete.
EN 23